SMC株式会社
User Manual for SMC models including: SMC-WEX08, SMCWEX08, 2AJE7SMC-WEX08, 2AJE7SMCWEX08, SMC-WEX08 Wireless Adaptor, EXW1-A1, Wireless Adaptor, EXW1-A1 Wireless Adaptor
SMC Corporation SMC-WEX08 Wireless Adaptor 2AJE7SMC-WEX08 2AJE7SMCWEX08 smc wex08
File Info : application/pdf, 8 Pages, 291.50KB
DocumentDocumentConfidential SMC Corporation PRODUCT NAME Wireless Adaptor Certificate Model EXW1-A1 Product Number EXW1-A1** No.DLZ-91028-WN037 Contents Introduction 4 Lineup 4 External appearance 4 Connections with Base/Remote units 5 Connector pin assignment 5 Wireless Specification 6 Product Specification 6 - 1 - No.DLZ-91028-WN037 Caution Notice: Changes or modifications not expressly approved by the manufacturer could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 1. Reorient or relocate the receiving antenna. 2. Increase the separation between the equipment and receiver. 3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 4. Consult the dealer or an experienced radio/TV technician for help. This equipment has been tested and found to comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference (2) This device must accept any interference received, including interference that may cause undesired operation. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device is authorized under Title 47 CFR 15.519 (the FCC Rules and Regulations). The operation of this device is subject to the following restriction: The changes or substitutions of the antennas which are furnished with the device is prohibited. FCC ID : 2AJE7SMC-WEX08 - 2 - No.DLZ-91028-WN037 This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. Caution This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. "Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device." Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil nedoit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. "This Class B digital apparatus complies with Canadian ICES-003." Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. "This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter." Cet appareil et son antenne (s) ne doit pas être co-localisés ou fonctionnant en conjonction avec une autre antenne ou transmetteur. "This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body" Cet équipement doit être installé et utilisé à une distance minimale de 20cm entre le radiateur et votre corps. - 3 - No.DLZ-91028-WN037 Introduction EXW1-A1 is a wireless adaptor which is equipped with 2.4GHz wireless communication capability. And this product has the RS485 interface for connection with SMC wireless Base/Remote units to communicate the input/output, diagnostic and other data. The frequency hopping period and the data rate can be selected between 2ms(1000kbps) / 5ms(250kbps). Moreover, the frequency channel numbers can be selected from 15 to 79. Lineup EXW1-A1 Product number EXW1-A11N EXW1-A12N EXW1-A13N EXW1-A11N-X1 Hardware version Ver.1.0.0 Ver.1.0.0 Ver.1.0.0 Ver.1.0.0 Wireless version Ver.1.0.0 Ver.1.0.0 Ver.1.0.0 Ver.1.0.0 software Control software version Ver.1.0.0 Ver.2.0.0 Ver.3.0.0 Ver.4.0.0 External appearance LED - 4 - No.DLZ-91028-WN037 Connections with Base/Remote units The wireless adaptor is connected to Base and Remote units via a cable. Connector pin assignment M8 4pin Connector Pin No. Description 1 24V 2 B (RS485) 3 0V 4 A (RS485) - 5 - No.DLZ-91028-WN037 Wireless Specification Model Product number Frequency range Frequency Channel Protocol Encryption Radio wave type Output level CCA Modulation Data Rate Deviation Frequency period hopping Antenna EXW1-A1 EXW1-A1*N 2.4GHz (2403MHz ~ 2481MHz) 79ch15ch (ch separation min.1MHz) SMC original protocol SMC original encryption FHSS 20dBm eirp Adaptive GFSK 1000kbps / 250 kbps 250kHz1000kbps / 62.5kHz250kbps 2ms(1000kbps) / 5ms(250kbps) Sleeve antenna (4.37dBi) Product specification Model Product number Wired interface Wired data rate Cable Communication distance Ambient operating temperature Ambient storage temperature Ambient humidity Power supply voltage Current consumption EXW1-A1 EXW1-A1*N RS485 Max. 2Mbps Max. 2.95m 100m -10 to +50oC -20 to +60oC 35 to 85% RH (no condensation) 12~24 VDC 10% 50m A - 6 - No.DLZ-91028-WN037 Revision history 4-14-1, Sotokanda, Chiyoda-ku, Tokyo 101-0021 JAPAN Tel: + 81 3 5207 8249 Fax: +81 3 5298 5362 URL http://www.smcworld.com Note: Specifications are subject to change without prior notice and any obligation on the part of the manufacturer. © 2022 SMC Corporation All Rights Reserved - 7 - No.DLZ-91028-WN037