Bosch SMV6ECX69E Dishwasher Quick Reference Guide

Setting up Home Connect

Tip: Connect your appliance to a mobile device for convenient settings changes via the Home Connect app.

1. Install the Home Connect app on your mobile device and follow the instructions.
2. Scan the [QR Code] with the Home Connect app. You can find the app on [Google Play] and [App Store].

Overview of Water Hardness Settings

This section provides an overview of selectable water hardness values. A table of country-specific units is available in the full instruction manual.

Setting the Water Softening System

1. Press the [Setup] button.
2. To open basic settings, press and hold the [Setup] button for 3 seconds. [Checkmark] The display shows H:xx. [Checkmark] The display shows set.
3. Press the [+/-] buttons repeatedly until the correct water hardness setting is displayed.
4. To save the settings, press and hold the [Setup] button for 3 seconds.

Adding Special Salt

To prevent appliance damage, add special salt only just before the program starts.

1. Unscrew the lid of the [Special Salt] dispenser and remove it.
2. On initial start-up: Fill the dispenser completely with water.
3. Add the special salt to the dispenser. The water will be displaced and forced out. Never add detergent.
4. Replace the lid on the dispenser and turn to close.

Adding Rinse Aid

1. Press the catch on the lid of the rinse aid dispenser and lift it open.
2. Add rinse aid up to the "max" mark.
3. Close the lid of the rinse aid dispenser. [Checkmark] The lid will click into position.

Adding Detergent

1. Add detergent to the dry detergent dispenser.
2. Close the lid of the detergent dispenser. [Checkmark] The lid will click into position.

Programmes

Programme data is measured according to European standard EN 60436. Consumption figures vary based on selected programs and functions. Runtime may change if the rinse aid system is switched off or rinse aid needs refilling.

¹ Suitable programme for running at night: takes longer, but is extremely quiet.

² Half standard load.

How to Use Your Appliance

Only clean tableware that is suitable for dishwashers. Remove large food remnants and check that spray arms can rotate freely.

1. Load the tableware.
2. Add detergent.
3. Switch on the appliance.
4. Select the programme.
5. Start the programme.
6. Remove the tableware at the end of the programme.
7. To cancel the programme, press and hold the [Reset] button for approximately 4 seconds. The programme will be cancelled and end after approximately 1 minute.

Cleaning Filters

After each wash, check filters for residue.

1. Turn the coarse filter anticlockwise and remove the filter system.
2. Pull down the micro filter to remove it.
3. Press the locking catches together and lift the coarse filter out.
4. Clean the filter elements under running water.
5. Re-assemble the filter system.
6. Insert the filter system into the appliance and turn the coarse filter clockwise. Ensure arrow markings align.

Cleaning Spray Arms

1. Unscrew the upper spray arm and pull it down to remove.
2. Pull up the lower spray arm to remove it.
3. Check the outlet nozzles on the spray arms for blockages under running water and remove any foreign bodies.
4. Insert the lower spray arm. It will click into position.
5. Insert the upper spray arm and screw it firmly in place.

Clean Wastewater Pump

1. Disconnect the appliance from the power supply.
2. Remove the filter system.
3. Scoop out any remaining water.
4. Pry off the pump cover using a spoon and grip it by the crosspiece.
5. Lift the pump cover inwards at an angle and remove it.
6. Remove any food remnants and foreign bodies from the impeller area.
7. Insert the pump cover and press down until it clicks into position.
8. Install the filter system.

Troubleshooting