Croydex Stick N Lock 8'6" Telescopic Rod

Model: AD1021**

Visit www.croydex.com for a helpful installation video.

Product Components

  • A: Telescopic Sections
  • B: Extra Section
  • C: Threaded Wall Bracket
  • D: Fixed Wall Bracket
  • E: Stick N Lock Rings
  • F: Protective Caps

Installation - DO

  • Clean the wall surfaces before mounting.
  • Extend the rod fully against the walls before locking.
  • Tighten the threaded bracket to fully tension the rod.
  • Ensure you are happy with the position of the rod before sticking it in place.
  • Apply pressure to the Stick N Lock rings for at least 30 seconds.

Installation - DON'T

  • The adhesive is NOT suitable for unfinished materials such as brick, block-work, wood, emulsion paint, loose, flaky surfaces or surfaces contaminated with grease, wax or dust.
  • DO NOT USE ON DECORATIVE WALL PAPER FINISHES.
  • Over-tighten the locking mechanism as you can damage the rod.

Safety and Care

  • Do not use this product as a grab bar.
  • Clean product regularly with a soft damp cloth but do not use abrasive or chemical cleaners, as these may damage the product.
  • Do not overload the rail. Suitable for use with a maximum of two standard shower curtains.
  • The adhesive is suitable for surfaces such as gloss paint, tiles, polished stone, laminates and textured surfaces.
  • Do not use tile cleaning chemicals on or around this product as they may affect adhesion.

Step-by-Step Installation Guide

  1. If required, increase the rod length by inserting the extra section. Maximum extension: 2600mm (1750mm without extra section).

  2. Ensure the wall brackets are inserted at the correct end. One is a Fixed Wall Bracket (thin section) and the other is an Adjustable Wall Bracket (thick section).

  3. Complete these steps for each wall bracket: Remove protective caps. Slide the Stick N Lock Rings onto the rod. Check O-Rings are in place.

  4. Ensure mounting points on the wall are clean and dry. Only wash with warm soapy water if needed.

    Action: TWIST TO UNLOCK

    Action: SLIDE & EXTEND BETWEEN THE WALLS. Ensure the rods are extended to press firmly against the walls.

    Action: TWIST TO LOCK WHILST UNDER TENSION. Be careful not to over-tighten the locking mechanism.

  5. Check the level and height to ensure that you are happy with the position of the rod. Then fully tension by twisting the collar of the threaded bracket anti-clockwise.

  6. Remove protective film from the Stick N Lock Rings. Press the Stick & Lock rings against the wall for 30 seconds, ensuring that even pressure is spread across the bracket. Your rod is now ready for use.

Explore the Croydex Range

Check out our full range of Bathroom Accessories:

Bathroom Accessory Sets

  • Heated Towel Rails
  • Bathroom Extractor Fans
  • Bathroom Lighting
  • Shower Seats
  • Grab Rails
  • Shower Curtains
  • Toilet Brushes
  • Bathroom Cleaning Products

Wall Mounted Bathroom Accessories

  • Robe Hooks
  • Bathroom Tumblers
  • Toilet Roll Holders
  • Soap Dishes
  • Towel Rings
  • Shower Caddies

Bathroom Mirrors

  • Standard Bathroom Mirrors
  • LED Bathroom Mirrors
  • Shaving Mirrors

Croydex, Central Way, Andover, Hampshire, SP10 5AW, UK

Phone: +44 (0) 1264 356437

Email: info@croydex.co.uk

Website: www.croydex.com

Customer Service: +44 (0) 1264 365881

Reference: R&R 066 R03

plumbworld - Big brands, small prices.

1-croydex-stick-n-lock-8ft6-telescopic-shower-enclosure-rod-installation-guide Adobe Acrobat Pro DC 18 Paper Capture Plug-in