Resistex FEBUS Lighting Fixture
Installation, Safety, and Maintenance Guide
Safety Instructions
Important Safety Notes:
- Never work on the luminaire when it is live (under voltage).
- Installation must be performed by a professional installer, adhering to all relevant electrical installation standards and regulations.
- Be aware of the risk of electrostatic discharges (ESD Norm). Handle the product with necessary precautions.
- Please observe all notes and follow the steps described in the mounting instructions carefully.
Maintenance Instructions
Maintenance Notes:
- Do not use chemical or abrasive products to clean the luminaire.
- Keep these instructions for future dismantling or maintenance work.
- Additional information about RESISTEX luminaires is available on the website: www.resistex-sa.com.
- RESISTEX cannot be held responsible for any misuse of the product.
Installation Guide
Wiring Connection
The wiring diagram illustrates the connection of the lighting fixture. Power is supplied via Live (L) and Neutral (N) lines. An 'On/Off' switch is connected in series with the Live wire before reaching the 'Driver'. The 'Driver' unit has positive (+) and negative (-) terminals that connect to the 'DOWN LIGHT' fixture.
Mounting / Installation Steps
-
Step 1: Prepare Cutout
A circular cutout is required in the ceiling. The recommended cutout diameter is 125 mm for a 140 mm fixture or 200 mm for a 220 mm fixture. The fixture can be rotated 360°.
-
Step 2: Connect and Insert
Connect the wires from the fixture to the driver, following the polarity (+/-). Then, insert the fixture into the prepared ceiling cutout.
-
Step 3: Secure Fixture
Push the fixture into the opening until it is securely seated.
-
Step 4: Final Installation
The fixture is now fully installed in the ceiling.
Certifications and Specifications
The FEBUS fixture meets various standards and offers specific features:
- Warranty: 5 years
- Certifications: CE, RoHS
- Ingress Protection: IP54 (protection against dust and water jets)
- Impact Resistance: IK06 (protection against mechanical impacts)
- Energy Efficiency: Greater than 80% [>80]
Company Information
Resistex Exploitation
Address: 11 Quai de la Banquière CS 80010, 06730 Saint-André-de-la-Roche - France
Phone: 04 93 276 276
Fax: 04 93 276 280
Email: contact@resistex-sa.com
Website: www.resistex-sa.com
APE Code: 2740Z
SIRET: 487 593 477 00010
SAS Capital: 649,979 €
VAT: FR 73 487 593 477