RYOBI 18V ONE+ Lithium-Ion Battery Pack

Safety Rules

WARNING! READ AND UNDERSTAND ALL INSTRUCTIONS. Failure to follow all instructions may result in electric shock, fire, and/or serious personal injury.

General Precautions

• Battery tools are always in operating condition as they are not plugged into an electrical outlet. Be aware of potential hazards when the tool is not in use or when changing accessories. Following this rule reduces the risk of electric shock, fire, or serious personal injury.
• Do not place battery tools or their batteries near fire or heat. This reduces the risk of explosion and possible injury.
• Do not crush, drop, or damage the battery pack. Do not use a battery pack or charger that has been dropped or received a sharp blow. A damaged battery is subject to explosion. Properly dispose of a dropped or damaged battery immediately.
• Batteries can explode in the presence of an ignition source, such as a pilot light. To reduce the risk of serious personal injury, never use any cordless product in the presence of open flame. An exploded battery can propel debris and chemicals. If exposed, flush with water immediately.
• Do not charge the battery tool in a damp or wet location. This reduces the risk of electric shock.
• Charge only with RYOBI™ ONE+™ 18V dual-chemistry battery chargers. Use of other chargers may result in personal injury, fire, or damage.
• Do not charge in extreme heat or cold. The battery works best at normal room temperature. To reduce the risk of serious personal injury, do not store outside or in vehicles.
• Under extreme usage or temperature conditions, battery leakage may occur. If liquid contacts skin, wash immediately with soap and water. If liquid gets into eyes, flush with clean water for at least 10 minutes, then seek immediate medical attention. Following this rule reduces the risk of serious personal injury.
• When the battery pack is not in use, keep it away from other metal objects like paper clips, coins, keys, nails, screws, or other small metal objects that can create a connection between terminals. Shorting the battery terminals together may cause sparks, burns, or a fire.
• Always remove the battery pack from your tool when assembling parts, making adjustments, cleaning, or when the tool is not in use. Removing the battery pack prevents accidental starting that could cause serious personal injury.
• Always remove the battery pack before storing the device.
• Always wear eye protection with side shields marked to comply with ANSI Z87.1. Failure to do so could result in objects being thrown into your eyes and other possible serious injuries.
• Keep the battery pack dry, clean, and free from oil and grease. Always use a clean cloth for cleaning. Never use brake fluids, gasoline, petroleum-based products, or any solvents to clean the battery pack.
• Do not use a battery pack that is damaged or modified. Damaged or modified batteries may exhibit unpredictable behavior resulting in fire, explosion, or risk of injury.
• Do not modify or attempt to repair a damaged battery pack.
• Do not expose the battery pack or appliance to fire or excessive temperature. Exposure to fire or temperatures above 265°F (130°C) may cause explosion.
• Have servicing performed by a qualified repair person using only identical replacement parts to ensure product safety.
• Save these instructions. Refer to them frequently and use them to instruct others who may use this tool. If loaning the tool, include these instructions.

Operation

Lithium-Ion Battery Packs

Lithium-ion batteries deliver fade-free power for their entire run time. Unlike older battery technologies, lithium-ion tools do not gradually lose power as the battery charge decreases. Instead, the power from the battery pack will drop from full to zero once the full charge has been drained. Recharging is required once this happens. It is not necessary to drain the battery pack completely before recharging.

Battery Protection Features

Lithium-ion battery packs are designed with features that protect the lithium-ion cells and maximize battery life.

If the tool stops during use, release the trigger to reset and resume operation. If the tool still does not work, the battery needs to be recharged.

Cold Weather Operation

The lithium-ion battery pack can be used in temperatures down to 14°F (-10°C). Put the battery pack on a tool and use the tool in a light-duty application. After about a minute, the pack will warm up and begin operating normally.

Battery Fuel Gauge

To display the amount of charge left in the battery, press the charge level indicator button:

Charging the Battery Pack

Battery packs are shipped in a low charge condition to prevent possible problems. Therefore, you should charge prior to first use. If the charger does not charge the battery pack under normal circumstances, return both the battery pack and charger to your nearest Authorized Service Center for electrical check.

Figure 1 Description: Shows the battery pack with a charge level indicator button and the charge level indicator lights.

• Charge the battery pack only with the recommended charger.
• Refer to the charger operator's manual for charging instructions.

Charging a Hot Battery Pack

When using a tool continuously, the battery pack may become hot. A hot battery pack may be placed directly onto the charger port, but charging will not begin until the battery temperature cools to within an acceptable temperature range. When a hot battery pack is placed on the charger, the charger may indicate the pack is not ready to charge. Please refer to the charger operator's manual. When the battery pack cools, the charger will automatically begin charging.

Charging a Cold Battery Pack

A cold battery pack may be placed directly onto the charger port, but charging will not begin until the battery temperature warms to within an acceptable temperature range. When a cold battery pack is placed on the charger, the charger may indicate the pack is not ready to charge. Please refer to the charger operator's manual. When the battery pack warms, the charger will automatically begin charging.

Maintenance

Batteries

These batteries have been designed to provide maximum trouble-free life. However, like all batteries, they will eventually wear out. Do not disassemble the battery pack and attempt to replace the batteries. Handling these batteries, especially when wearing rings and jewelry, could result in a serious burn.

For Battery Pack Storage Longer Than 30 Days:

• Store the battery pack where the temperature is below 80°F (27°C) and away from moisture.
• Store battery packs in a 30%-50% charged condition.
• Every six months of storage, charge the pack as normal.

Battery Pack Removal and Preparation for Recycling

Recycling Symbol: [Recycling Symbol] To preserve natural resources, please recycle or dispose of batteries properly. This product contains lithium-ion batteries. Local, state, or federal laws may prohibit disposal of lithium-ion batteries in ordinary trash. Consult your local waste authority for information regarding available recycling and/or disposal options.

WARNING! Upon removal, cover the battery pack's terminals with heavy-duty adhesive tape. Do not attempt to destroy or disassemble the battery pack or remove any of its components. Batteries must be recycled or disposed of properly. Also, never touch both terminals with metal objects and/or body parts as short circuit may result. Keep away from children. Failure to comply with these warnings could result in fire and/or serious injury.

SAVE THESE INSTRUCTIONS.

Contact and Support

To request service, purchase replacement parts, locate an Authorized Service Center, or obtain Customer or Technical Support:

• Visit: www.ryobitools.com
• Call: 1-800-525-2579

If any parts or accessories are damaged or missing, do not return this product to the store. Call 1-800-525-2579 for immediate service.

Please obtain your model and serial number from the product data plate.

This product is covered under a 3-year limited Warranty. Proof of purchase is required.

Model Number: [Model Number Field]

Serial Number: [Serial Number Field]

*Model number on product may have additional letters at the end. These letters designate manufacturing information and should be provided when calling for service.

RYOBI is a trademark of Ryobi Limited and is used pursuant to a license granted by Ryobi Limited.

TTI Consumer Power Tools, Inc. P.O. Box 1288, Anderson, SC 29622 • Phone: 1-800-525-2579