User Instruction
Congratulations on your new inflatable product purchase! Please read all instructions carefully before use.
Precautions ⚠️
- Ensure electrical source is safe and stable before operation.
- Keep children away from blower. Do not insert fingers, toes, etc. into the blower, as it may cause injury. Do not insert foreign objects into the blower. This will cause damage.
- Do not bring sharp objects into the play area.
- Do not eat in the play area.
- Do not smoke in the play area.
- Keep product away from fire and heat.
- In case of blower malfunction, tighten the blower vent and evacuate the play area immediately.
- Do not use in rain, strong wind, or extreme weather conditions.
- Observe precautions on the product WARNING LABEL at all times.
STEP 2: Setup
- Product should be assembled by an adult.
- Unroll product evenly across a smooth, flat, debris-free surface. Connect blower(s) to the inlet, and tie. Anchor the blower to the ground using the stakes provided.
- Plug in and start the blower. If your item uses multiple blowers, connect all blowers to their inlets. Make sure all blowers are powered off (blower models with switch). Plug in all blowers, then switch them on one at a time at 20-second intervals.
- Once inflated, anchor the inflatable product to the ground using the stakes provided.
STEP 3: Disassembly
- Ensure that all players have left the play area.
- Remove any loose articles or debris from the play area.
- Turn off and unplug the blower.
- Once the product is fully deflated, fold and store in a cool, dry area.
STEP 4: Maintenance & Repairs
- Always keep products clean to protect the seams and surface.
- Regularly inspect seams and play surface for any necessary repair. Slight damage caused by nature or man-made factors can be repaired with the repair kit provided.
- To repair, deflate the product thoroughly and ensure the surface is dry. Cut patches to sizes suitable for repair. Apply glue on both the repair patches and the damaged surface. Allow the glue to air-dry for 30 seconds before adhering the patch to the play surface. Allow to dry for at least 4 hours before use.
NOTE:
- Maximum weight of user: 100 lbs each.








