Zipwake Startup Checklist
Zero Pitch & Roll Angles?
Check if the system displays zero pitch and roll angles.
If NO: Tap $\equiv$, then tap AUTO Setup, then tap Boat Data, and change if incorrect. Then, tap $\equiv$, tap Angles Setup, tap Reset Pitch & Roll, and confirm the orientation angle (Refer to Operator's Manual).
If YES: Proceed.
Boat Data:
- Boat Length: 9 m
- Boat Beam: 2.5 m
- Boat Weight: 5000 kg
- Hull Type: Mono
Red GPS Symbol Visible?
Check for a red GPS symbol on the display.
If NO: Tap $\equiv$, then tap Select GPS Source, then tap Change Source, and continue.
If YES: Tap $\equiv$, then tap Select GPS Source, then tap Change Source, and continue.
Auto Mode On?
Check if Auto Mode is active.
If NO: Tap FULL AUTO.
If YES: GO!
Main Menu Overview
The Integrator Module provides access to various system settings:
- System information: View system units, status, and data.
- AUTO Setup: Edit AUTO Pitch Curve and boat data.
- Interceptor Setup: Configure AUTO Cleaning and run interceptor tests.
- Angles Setup: Select and view the current status of Pitch & Roll and Integrator Module Orientation.
- Select GPS Source: Configure GPS settings and view current status.
- Set Units: Adjust units for Speed, Length, Weight, etc.
- Select Language: Choose the system language.
- Advance Setup: Access upgrade options, pitch curve export/import, and factory reset.
To Reset Pitch & Roll Angles:
- Level the boat.
- Tap $\equiv$.
- Tap Angles Setup.
- Tap Reset Pitch & Roll.
- Confirm Orientation Angle (Refer to Operator's Manual).
Change GPS Source
To change the GPS source:
- Tap $\equiv$.
- Tap Select GPS Source.
- Tap Change Source.
- Continue.
Diagram Description: Stansat hål
A circular diagram indicating a punched hole ('Stansat hål') with a diameter of 45 mm, with a tolerance of +/- 0.5 mm. Dashed lines indicate the center and perpendicular axes. An arrow points to the edge of the circle, labeled 'Uppklippt' (cut out).
