User Guide for JSAUX models including: PC0106A Transparent Back Plate RGB Version, PC0106A, Transparent Back Plate RGB Version, Back Plate RGB Version, Plate RGB Version, RGB Version
JSAUX Transparent Back Plate RGB Version Compatible for Steam Deck, DIY Clear Edition Replacement Shell Case Compatible with Steam Deck - PC0106 RGB Version [Crystal] : Video Games
PC0106A RGB Back Plate for Steam Deck Product Overview Screw Position Switch Key Touch Position Aluminum Sheet Back Bu on Original Edition Key Lower Key Higher Key A ention Regarding the changes in the maintenance policy of the whole machine caused by teardown, please refer to the official information provided by VALVE. Before you begin, completely power down and unplug all cables from your Steam Deck. Remember to follow general electrostatic discharge (ESD) safety procedures while repairing the device. To minimize risk of damage, turn on your Steam Deck and allow the ba ery to discharge below 25% before starting your repairs. A charged lithium-ion ba ery can be very dangerous if accidentally punctured. Before starting this guide, power down your Steam Deck and unplug any cables. As an extra precaution, Valve recommends pu ing your Steam Deck into ba ery storage mode within the BIOS before starting any internal repairs. If you have a microSD card installed, make sure to remove it before opening the Steam Deck. Throughout this repair, keep track of each screw and make sure it goes back exactly where it came from to avoid damaging your Steam Deck. Do not touch the aluminum alloy back cover when the game machine is in use to avoid burns. Thermal silicone grease can be heated and softened with a heat gun or air blower before use to ensure fit. If the key is stuck after the back cover is installed, you can loosen the screws near the key position. Notice 1. Before installing the new rear cover, check whether the FPC link between the light board and the motherboard is normal and ensure that the power can be turned on properly before installation. 2.When replacing the key, pay a ention to the left and right positions of the light board. Installation 1.Select the Bu on We have included three keys with different heights and feel, you can use screws to fix them on the back cover, fully feel the difference in feel and choose the most suitable height for you. 2.Remove the back cover screws Use a Phillips driver to remove the eight screws securing the back cover. 3. Unclip the back cover Insert an opening pick into the thin gap between the back cover and the front shell, along the edge of the right grip. 4.Remove the back cover Grip the back cover at the opening you just created and pull it up and away from the device to unclip the long edges. 5.Install new back cover Align the new back cover with the back bu ons fixed on the buckle on the machine, press to close the buckle, and then screw back the screws on the back of the machine in the order of disassembly Parameters Brand: JSAUX Product Model: PC0106A Product Name: RGB Back Plate for Steam Deck Product Material: ABS+PC+Aluminium Alloy Product Size: About 150(L) x 117(W) x 32(H)mm Product Weight: About 127.5g Ba ery Life: About 2h,ba ery life varies with different lighting modes Charging Time: About 30min Ba ery Capacity: 150mAh Packing Accessories (×1)RGB Back Plate for Steam Deck (×2)Original Edition Key (×4)Higher Key (×4)Lower Key (×1)Magnetic Charging Cable ToolsAdobe PDF library 15.00