K3 Desktop Clock Wireless Speaker

Instructions

This section provides instructions for operating the K3 Desktop Clock Wireless Speaker.

Key Operation

1. Date and Time Setting: Long press to enter date settings. Short press to cycle through "year/month/day/hour/minute" settings. Use +/- buttons to adjust flashing numbers. Long press to confirm.

2. Alarm Setting (Two Alarms): Short press the indicator light to turn on. Long press to enter the alarm setting program. Short press to switch between "hours/minutes/alarm ringtone/alarm volume" settings. Use +/- buttons to adjust. Long press to confirm. The setting for the second alarm is the same as the first. Press any button to cancel the reminder when the alarm rings.

3. Alarm Switch: Short press to cycle through 4 alarm modes: ①, ②, ③, or None.

4. 12/24-Hour Setting: Double-click to enter 12/24-hour settings. Click to switch. Long press to complete.

M Button Functions

• Long Press: Switch modes (Wireless/FM/TF).
• Wireless Mode: Click to play/pause.
• Call Mode: Click to answer/hang up, long press to reject.
• FM Mode: Click to automatically search for stations (plug in the charging cable to enhance signal).
• TWS Function: Triple-click.

Volume and Track Control

• Wireless Mode: Click to decrease volume, long press for previous song. Click to increase volume, long press for next song.
• Clock/Alarm Mode: Click to decrease. Click to increase.

Pairing Steps

Connect to mobile devices such as smartphones.

1. After booting up, turn on the Bluetooth function of your phone, select the corresponding name to pair. Pairing is successful when connected.
2. If there is no operation for 1 minute, the device automatically enters energy-saving mode, and the RGB lights dim. Press any button to restore brightness.
3. If the Bluetooth function is not connected for 3.5 minutes, it will automatically turn off. It can be restarted by pressing any button.

Note on Time Synchronization:

• After successfully connecting to an Apple device, the phone time will be automatically synchronized.
• After successfully connecting to an Android device, a pop-up window will appear requesting access to information. Click 'allow' to synchronize your phone time.

Indicator Light

Lightning Indicator Light: Stays on during charging, flashes when the battery is low, and turns off when fully charged.

Product Parameters

FCC Compliance Information

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement: The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.