Akuvox | The Leader in Smart Intercom
User Guide for Akuvox models including: X912 IP Vandal Resistant Smart Door Intercom Unit, X912, IP Vandal Resistant Smart Door Intercom Unit, Resistant Smart Door Intercom Unit, Smart Door Intercom Unit, Door Intercom Unit, Intercom Unit
Вызывная панель Akuvox X912S распознавание лиц NFC и Bluetooth - Nadzor.ua
X912 Insertthefourplasticwall anchorsintothedrilledholes. Asfigureshown,markfourscrewholeson thepositionthataccordingtothecableplace ...
File Info : application/pdf, 4 Pages, 283.39KB
DocumentDocumentX912 Quick Guide Unpacking Before you begin using the device, please check the version you got and ensure that the following items are included in the shipped box: Rotary bracket x1 M4X10 crosshead screw x5 X912 Installation As figure shown, mark four screw holes on the position that according to the cable place. The horizontal distance of two holes should be 50 mm, and the vertical distance of two holes should be 180 mm. Then use a hand drill with a diameter of 6 mm to drill the four marked holes with a depth of 20 mm. Insert the four plastic wall anchors into the drilled holes. X912 Rotate right in 30 degrees Rotate left in 30 degrees Or Place the rotary bracket closely against the wall while lining up its four holes with their corresponding drilled holes. And then fasten the rotary bracket on the wall by tightening four ST4x20 crosshead screws to the plastic wall anchors. Rotate right 30 degrees Rotate left in 30 degrees Or Fix wall-mounting bracket with five M4x10 crosshead screws on the rotary bracket. X912 Note Information Information contained in this document is believed to be accurate and reliable at the time of printing. This document is subject to change without notice, any update to this document can be viewed on Akuvox' s website: http://www.akuvox.com © Copyright 2022 Akuvox Ltd. All rights reserved.