User Manual for SMC models including: SMC-WEX07, SMCWEX07, 2AJE7SMC-WEX07, 2AJE7SMCWEX07, P5740-162 Wireless Module, Wireless Module
SMC Corporation SMC-WEX07 Wireless module 2AJE7SMC-WEX07 2AJE7SMCWEX07 smc wex07
PRODUCT NAME Wireless module MODEL / Series / Product Number P5740-162 No.DLX-91006-ZZ092 Contents Introduction 4 Specification 4 Pin description 5 Dimensions 6 -1- No.DLX-91006-ZZ092 Caution Notice: Changes or modifications not expressly approved by the manufacturer could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 1. Reorient or relocate the receiving antenna. 2. Increase the separation between the equipment and receiver. 3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 4. Consult the dealer or an experienced radio/TV technician for help. This equipment has been tested and found to comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference (2) This device must accept any interference received, including interference that may cause undesired operation. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device is authorized under Title 47 CFR 15.519 (the FCC Rules and Regulations). The operation of this device is subject to the following restriction: The changes or substitutions of the antennas which are furnished with the device is prohibited. FCC ID : 2AJE7SMC-WEX07 IC: 21344-WEX07 -2- No.DLX-91006-ZZ092 This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. Caution This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. The antenna must be installed by a professional. "Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device." Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil nedoit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. "This Class B digital apparatus complies with Canadian ICES-003." Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. "This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter." Cet appareil et son antenne (s) ne doit pas être co-localisés ou fonctionnant en conjonction avec une autre antenne ou transmetteur. "This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body" Cet équipement doit être installé et utilisé à une distance minimale de 20cm entre le radiateur et votre corps. End Product Labeling This transmitter module is authorized only for use in device where the antenna may be installed such that 20cm may be maintained between the antenna and users. The final end product must be labeled in a visible area with the following: "Contains FCC ID: 2AJE7SMC-WEX07 " and "Contains IC: 21344-WEX07 " Information for the OEMs and Integrators The following statement must be included with all versions of this document supplied to an OEM or integrator, but should not be distributed to the end user. 1) This device is intended for OEM integrators only. 2) Please see the full Grant of Equipment document for other restrictions. This radio transmitter FCC ID: 2AJE7SMC-WEX07 and IC: 21344-WEX07 has been approved by FCC to operate with the antenna types listed below with the maximum permissible gain and required antenna impedance for each antenna type indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device. -3- No.DLX-91006-ZZ092 Introduction P5740-162 is a wireless module which provides a SPI interface for MCU communication.It comes with the SMC original protocol using 2.4GHz ISM band. The frequency hopping period and the data rate can be switched between 2ms(1000kbps) / 5ms(250kbps). Moreover, the frequency channel numbers can be selected from 5 to 79. Specification Wireless module model No. Wireless module version Frequency range Frequency Channel Protocol Encryption Radio wave type Output level CCA Modulation Data Rate Deviation Frequency hopping period Antenna Dimensions Weight Ambient operating temperature Ambient storage temperature Ambient humidity Power supply voltage Current consumption P5740-162 Hardware : Ver.1.00 Wireless software : Ver.1.00 2.4GHz (2403MHz ~ 2481MHz) 79ch15ch (ch separation min.1MHz) SMC original protocol SMC original encryption Frequency Hopping Spread Spectrum (FHSS) 20dBm eirp Adaptive GFSK 1000kbps / 250 kbps 250kHz1000kbps / 62.5kHz250kbps 2ms(1000kbps) / 5ms(250kbps) PCB antenna(1.83dBi) / Whip antenna(1.49dBi) 42.4 24.0 7.8mm 5g -10 to +50oC -20 to +60oC 35 to 85% RH (no condensation) 3.3 VDC 5% 90m A -4- No.DLX-91006-ZZ092 Pin Description Pin No. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 Name 3.3V_C N.C. 3.3V_C N.C. NIRQ PB11 PB12 PB13 PC11 PF4 PF7 N.C. EFR_RQ1 I2C0_SDA EFR_RQ2 I2C0_SCL N.C. BUSBY_BUSAX OPA0_P OPA0_N OPA0_OUT N.C. US0_CS US0_RX US0_TX US0_CLK N.C. 0V_US1 N.C. 0V_US1 Description VCC +3.3V DC No Connection VCC +3.3V DC No Connection I2C interrupt : Output Digital I/O Digital I/O Digital I/O Digital I/O Digital I/O Digital I/O No Connection Request from MCU : Input I2C Data : Input/Output Request to MCU : Output I2C Clock : Output No Connection Analog I/O Analog I/O Analog I/O Analog I/O No Connection SPI Chip Select : Input SPI Rx : Input SPI Tx : Output SPI Clock : input No Connection Ground No Connection Ground 2Pin 1Pin 30Pin 29Pin -5- No.DLX-91006-ZZ092 Dimensions ·P5740-162 -6- No.DLX-91006-ZZ092 Revision history 4-14-1, Sotokanda, Chiyoda-ku, Tokyo 101-0021 JAPAN Tel: + 81 3 5207 8249 Fax: +81 3 5298 5362 URL http://www.smcworld.com Note: Specifications are subject to change without prior notice and any obligation on the part of the manufacturer. © 2021 SMC Corporation All Rights Reserved -7- No.DLX-91006-ZZ092Microsoft Word 2016