FLOS Aim Multiple Rose

Installation and Use Instructions

Warnings

• The safety of this fitting is guaranteed only by observing these instructions during both installation and use. Keep these instructions for future reference.
• Always ensure the power supply has been switched off before installation or any maintenance.
• Do not modify or tamper with the appliance in any way, as this can compromise safety and make it dangerous. FLOS is not responsible for modified products.
• The multiple rose allows for up to five separate light fittings to be turned on, or simultaneous turn-on of two to five light fittings.
• Installation must be performed by qualified personnel. If you are not familiar with electrical connections, consult a qualified electrician.
• The symbol ♻️ on the device indicates that the product must be disposed of separately from urban waste.

Cleaning Instructions

• Use only a soft cloth to clean the appliance. For stubborn dirt, the cloth can be dampened with water and soap or a mild cleanser.
• Warning: Do not use alcohol or other solvents.

Assembly Instructions

General Notes

Note: Select and use screw anchors suitable for the specific mounting surface.

Assembly Steps

• Step 1: Prepare the ceiling attachment and fixture plate. Ensure the correct screw anchors are selected for the mounting surface. (Diagrams show components and anchor selection).
• Step 2: Mount the ceiling attachment and the fixture plate to the junction box using the provided screws. (Diagrams show these components being attached).
• Step 3: Remount the rose to the ceiling attachment. (Diagram shows the rose being placed onto the attachment).
• Step 4: To adjust the height of the fitting, run the power cable through the cable glands. To adjust the tilt of the head, rotate a cable gland to manage the power cable length. (Diagrams illustrate height adjustment and head tilt).
• Step 5: Dismount the cable lock from the ceiling attachment by unscrewing it. Pass the power cables from the device through the rose, the cable gland (ensure the correct gland is used for the number of cables), the ceiling attachment, and the fixture plate. (Diagrams show cable routing and component disassembly/assembly).
• Step 6: Make the electrical connections in the Junction Box. Connect the wires according to color coding: Black wire to Black (L), White wire to White (N), and Green wire to Earth (GND). (Diagrams show wire connections).
• Step 7: Lock the power cables securely by remounting the cable locks. (Diagrams show securing the cables).
• Step 8: The multiple rose feature allows for flexible lighting configurations, enabling up to five separate light fittings to be controlled independently, or a simultaneous turn-on for two to five light fittings.