ifi GO pod TWS DAC Amp
Portable True Wireless Stereo (TWS) Digital-to-Analog Converter and Amplifier
Product Overview
The ifi GO pod consists of a pair of wireless earbuds and a compact charging case. The earbuds are designed for portable audio listening, featuring a TWS (True Wireless Stereo) DAC and amplifier. The charging case provides power and storage for the earbuds.
Diagram References:
- 1: Earbuds (Left and Right)
- 2: Touch control area on earbuds
- 3: USB-C charging port on the case
- 4: Charging case with earbuds docked
- 5: Charging case from a different perspective
LED Indicators
| Bluetooth LED | Status |
|---|---|
| off | Wireless Bluetooth (Connected) |
| Blue (flashing) | Wireless Bluetooth (Awaiting connection) |
| Blue/Red (flashing) | Wireless Bluetooth (Pairing) |
| Blue/Green (flashing) | Factory Reset |
| Red (long highlight) | Charging |
Touch Control Area
- Volume control: Turn the touch area.
- Play/Pause/Answer Call: A short click.
- Skip Forward: Two short clicks.
- Skip Back: Three short clicks.
- Wake up Voice Assistant: Long press (≥1.5 seconds).
- Pairing: Press the left and right touch areas together (≥ 2 seconds).
- Factory Reset: Long press (≥15 seconds).
USB-C Battery Charge Input
For charging the GO pod. Use a 5V/2A or higher Qi-certified charger, or a 5V/1A or higher Type-C charger.
LED for Battery Status
Note: Battery LED will flash when charging and will go out when fully charged.
| LED Indicator | Status |
|---|---|
| 4/4 | > 75% |
| 3/4 | > 50% |
| 2/4 | > 25% |
| 1/4 | < 25% |
Specifications
| Bluetooth version | Bluetooth 5.2™ |
|---|---|
| Codecs | AAC, SBC, aptX, aptX HD, aptX Adaptive, aptX LL, LDAC, LHDC/HWA Codec |
| Chipset | Qualcomm QCC 5100 Series |
| Auto impedance detection | 16Ω/32Ω/64Ω/300Ω |
| DNR | ≥129dB (A) |
| SNR | 32Ω ≥129dB (A) / 300Ω ≥132dB (A) |
| THD + N | ≤0.002% (1kHz/32Ω) |
| Output Noise | <1uV |
| Frequency response | 10-43kHz (-3dB) LDAC |
| Channel separation | ≥90dB (1kHz/32Ω) |
| Battery | Earbud: 180mAh + Charging box: 1500mAh |
| Working hours | Earbud: ~7h + Charging box: ~30h |
| Charging time | Earbud: ~1.5h + Charging box: ~2h |
| Power System | 5V/2A and above Qi certified charger, 5V/1A and above Type-C charger |
| Dimensions |
Earbud: 43.5 x 16.4 x 9.5 mm (1.7" x 0.6" x 0.4") Charging box: 116 x 76 x 38.5 mm (4.6" x 3" x 1.5") |
| Net weight |
Earbud: 12g (0.42 oz) Charging box: 126g (4.44 oz) |
| Limited Warranty | 12 months* |
*12 months typical or as permitted/required by local reseller laws.
**Specifications are subject to change without notice.
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
FCC Radiation Exposure Statement: The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
