Ronix 8627C 20V Cordless Blower

Technical Specifications

Part List

The blower consists of the following parts:

• Blow Nozzle
• Extension Tube
• Speed Regulator Knob
• ON / OFF Switch
• Motor Housing
• Handle

A diagram illustrates the assembly of these parts.

General Safety Instructions

WARNING: Read all safety warnings and instructions carefully before operating the device. Failure to follow these instructions may result in personal injury or damage to the device.

• This device is not intended for use by children or persons with limited physical, sensory, or mental abilities, or those lacking experience and knowledge, unless supervised.
• Children must not play with the device. Cleaning and maintenance must not be carried out by children.
• Ensure you are familiar with the controls and proper use of the machine.
• Local regulations may specify the minimum age for operating this device.

Preparation

• Wear ear protection and protective goggles during operation.
• Avoid wearing loose clothing or jewelry that could be caught in the suction opening.
• Keep long hair away from the vents.
• Perform a visual inspection before use to ensure all fasteners are secure, the housing is undamaged, and guards are in place.

How to Use

Connecting the Blowing Nozzle

When connecting the nozzle and the extension tube, align the gap of the nozzle with the protuberance of the extension tube. Press down until the positioning point of the extension tube reaches the upper wall of the nozzle gap. Rotate the blowing nozzle clockwise until the positioning point reaches the snap position.

When connecting the blowing nozzle and the main body, ensure proper alignment as shown in the diagrams.

Starting and Adjusting the Gear

Press the power switch to start the device. Adjust the speed using the Speed Regulator Knob, which offers three speed settings.

Instructions for Use of Bent Nozzle

1. Extension tube + bent nozzle (reverse direction): For blowing leaves, debris, or dust from high places.
2. Extension tube + bent nozzle: For blowing leaves, debris, or dust from the ground.
3. Only bent nozzle: For blowing dust and foreign objects on a working table.

Instructions for Use of Concentrating Nozzle

1. Extension tube + Concentrating nozzle: For blowing foreign objects like dust or spider webs from high places.
2. Extension tube + bent nozzle: For blowing leaves, debris, or dust from the ground.
3. Only bent nozzle: For blowing foreign objects from a working table.

Instructions for Use of Flat Nozzle

• Extension tube + flat nozzle: For blowing leaves, debris, or dust from the ground. A wide flat nozzle is recommended for higher efficiency.
• Only flat nozzle: For blowing foreign objects from a working table. A wide flat nozzle is recommended for higher efficiency.

Instructions for Using Inflatable Blowing Nozzles

These nozzles can be used to inflate swimming rings, small kayaks, etc.

Angle Adjustment

The device features a rotation function, allowing the handle and body to be optionally installed at a 270° angle for suitability in different working environments. To adjust the angle, hold the body with one hand and the handle with the other. Rotate the body clockwise or counterclockwise with the hand holding the body to achieve the desired angle.

Cleaning

Important: Do not spray the device with water or immerse it in water, as this poses a risk of electric shock.

• Keep the ventilation slots, motor housing, and handles clean using a damp cloth or brush. Do not use cleaning agents or solvents, as they can cause irreparable damage.
• A. Keep ventilation slots free of dust and debris to prevent overheating.
• B. Clean the blower regularly with a soft cloth, preferably after each use. If dirt is stubborn, use a soft cloth dampened with soapy water.
• C. Never use solvents such as gasoline, alcohol, or ammonia water for cleaning, as they can damage plastic parts.