Installation Guide for airLive models including: 1004-10G Managed Switch Smart Network Solution, 1004-10G, Managed Switch Smart Network Solution, Switch Smart Network Solution, Smart Network Solution, Network Solution, Solution
AirLive ONU-10XG(S)-1004-10G Quick Installation Guide V1.0 AirLive ONU-10XG(S)-1004-10G QIG_V1.0 1. Indicator and Interface Description 1.1 Product Picture Figure 1. ONU-10XG(S)-1004-10G 1.2 Application Chart Figure 2. Application Chart (when using XG model the speed will be 10G DL / 2.5G UL) 1.3 Panel Lights LED Power Mark PWR Figure 3. Panel Lights Status On Off Description Device is powered up. Device is powered down. Registration PON Optical signal WAN LOS WAN Interface LAN1-5 USB USB AirLive ONU-10XG(S)-1004-10G QIG_V1.0 On Off Blink Off Blink On Off On Off Blink On Off Blink Device is registered to PON system. Device is not registered to PON system. Device is registering. Device has received optical signal. Device does not receive optical signal. WAN connection is up. WAN connection is down. Port is connected properly (LINK). Port is not connected properly. Port is sending or/and receiving data (ACT). USB device is connected, but without ongoing data transmission. Device is powered off or USB device is not connected. USB is with ongoing data transmission. Table 1. Panel Lights 1.4 Interface/button Panel Figure 4. Interface/button Panel, RST and USB on the side of the device. Name ON/OFF DC 12V LAN1-5 PON RST USB 3.0 Function Power switch. Connect with power adapter. DC 12V, 1A. The silver LAN1 is a 10GE port and the yellow LAN2~5 are 1GE ports. Connect PC or other devices to GE port by Cat5 cable, RJ-45 connector. And connect to the 10GE port by Cat6a cable, RJ-45 connector. Connect to OLT by SC type fiber connector, single mode optical fiber cable. Press RST button over 10 seconds, ONU restores factory default and reboots. External USB port, connect to USB storage device. Table 2. Interface/button Panel 2. Packing List Contents 10G-XG/XGS-PON ONU Installation Guide Quantity 1 pcs 1 pcs AirLive ONU-10XG(S)-1004-10G QIG_V1.0 Contents Power adapter Network cable Quantity 1 pcs 1 pcs 3. Hardware Installation Installation Environment Requirements ONU device must be installed indoors and ensure the following conditions: Confirm that there is sufficient space for ONU installation to facilitate cooling the device. ONU is suitable for working at temperatures ranging from -5 to 55 and humidity ranging from 10% to 90%. ONU workplace should avoid high-frequency interference from radio transmitters, radar stations, and power equipment. Equipment Installation 1. Installed on the desktop Place the ONU on a clean bench, this installation is relatively simple, you can observe the following operation: Ensure a smooth surface. There is enough space around the device for heat dissipation. Do not place objects on the device. 2. Mounted on the wall The ONU chassis has two recesses on the back, in accordance with the position of the groove, install two screws in the wall. The mounting two mounting screws gently snap into recesses when aligned. Slowly let go, so that the device under the support of the screws is hanging on the wall. 3. Connect fiber, network cable and power adapter to the corresponding interfaces, and turn on the power of product.Microsoft Word for Microsoft 365