FP-1000 National Instruments Network Interface | Apex Waves
User Guide for NATIONAL INSTRUMENTS models including: FP-1000 Network Interface, FP-1000, Network Interface, Interface
FP-1000 National Instruments Network Interface | Apex Waves
File Info : application/pdf, 2 Pages, 1.35MB
DocumentDocumentFP-1000 FieldPoint Note to Users USING THIS PRODUCT SAFELY IN HAZARDOUS LOCATIONS This equipment is suitable for use in Class I, Division 2, Groups A, B, C, D, T4 hazardous locations; Class I, Zone 2, AEx nC IIC T4 and Ex nC IIC T4 hazardous locations; and nonhazardous locations only. Cautions Explosion hazard--Substitution of components may impair suitability for Class I, Division 2 and Class I, Zone 2. Explosion hazard--Do not disconnect equipment unless power has been switched off or the area is known to be nonhazardous. For screw-terminal connections on the FP-1000, FP-1001, and FP-TB-1, use 1626 AWG copper wire with 7 mm (0.28 in.) of insulation stripped from the end. Tighten screw terminals to 0.50.6 N m (4.45.3 lb in.) of torque. Special Conditions for Safe Use in Europe This equipment has been evaluated as EEx nC IIC T4 equipment under DEMKO Certificate No. 02 ATEX 0148639X. Each module is marked II 3G and is suitable for use in Zone 2 hazardous locations. Cautions Equipment must be installed in a minimum IP 54 enclosure. Equipment must be used within its electrical and environmental ratings. Refer to the Specifications section of the product manual. Refer to the product label for manufacturing location. FieldPointTM, National InstrumentsTM, NITM, and ni.comTM are trademarks of National Instruments Corporation. Product and company names mentioned herein are trademarks or trade names of their respective companies. For patents covering National Instruments products, refer to the appropriate location: Help»Patents in your software, the patents.txt file on your CD, or ni.com/patents. 323543A-01 December 2002 © 2002 National Instruments Corp. All rights reserved.