PowerLocus Universe

Specifications

• Bluetooth Version: 5.3
• Working Distance Range: 10M
• Speaker dimension: 40 mm
• Frequency Range: 20Hz-20kHz
• Charging Voltage: DC 5V
• Sensitivity: 100dB+/-3dB
• Charging time: around 3 hours
• Playtime: 60 Hours (70% volume) | ANC ON : 30 Hours
• Frequency band: 2.4000 GHz - 2.4835 GHz
• Operating frequency: 2 400 MHz - 2 483.5 MHz
• Rated power consumption: 20mw
• Maximum output power: < 10 dBm
• Operating temperature of the products: -20C to 60C

How to Charge the Headphone

A voice prompt 'Battery low' allows for 2 minutes play time before the headphones power down stating 'Battery low, power off'. The LED Indicator Light 9 will flash WHITE once and then switch off. Connect the headphones to a suitable USB wall charger, computer USB port or a power bank using the USB-C Charging Cable 14 supplied and connect it to the headphones USB-C Charging Port 10. While charging, the LED Indicator Light 9 will glow WHITE. Once the headphones are fully charged, the LED Indicator Light 9 will turn off. Charging can take up to 2 hours.

How to Connect the Headphones

First Time Pairing

Power On 5. Press the multi-function button to turn on. A voice prompt 'Power on, pairing' confirms the headphones are on and in pairing mode. The LED Indicator Light 9 will flash WHITE and BLUE, ready to pair with your audio device. Go to the Bluetooth settings on your audio device to select 'PowerLocus Universe' from the list. Once paired successfully, you will hear 'Connected' and the LED Indicator Light 9 will switch off. You can now enjoy your music, watch a video or take a call handsfree. The headphones will automatically reconnect to the last device they were paired with, confirming 'Connected'. If there is no Bluetooth connection after 5 minutes, the LED Indicator Light 9 will begin to flash BLUE and WHITE for 60 seconds. The headphones will then automatically turn off by confirming with 'Power off' and the LED Indicator Light 9 will flash White once and then switch off.

Operations

• Play / Pause: Short press Call / Play / Pause Button 5.
• Volume Up / Down: Short press the Volume Up / Down Buttons 4/6 to adjust the volume.
• Skip / Previous Track: Press and hold the Skip / Previous Track Buttons 4/6 to change tracks.
• Active Noise Cancellation (ANC) On / Off and Transparent Mode: Short press the ANC button 8 to cycle through the following modes: TRANSPARENT MODE > ANC ON > ANC OFF. You will hear a voice announcement telling you which mode you are in: 'Transparent On', 'ANC On' or 'ANC Off'. The ANC LED light 7 will glow GREEN while either Transparent mode or ANC mode is being used.
• Change the Preset Equalisation (EQ) Settings: Choose from Equalisation (EQ) modes to suit your personal preference. There is no App required. Bass boost mode increases the bass sound. Short press the EQ button 13 to cycle through the Music and Bass Boost.
• Answer / End a call: Short press the Call Button 5. (Audio is picked up via the microphones 12.
• Power On / Off: Press and hold the multi-function button 5 on / off. You will hear 'Power on / off'.
• How to Reset?: Press and hold the + and - button for 6-7 seconds until the LED lights start flashing again in Blue/White.

Wired Mode

The headphones are suitable for devices with a 3.5mm audio socket. Insert the 3.5mm audio cable into the 3.5mm Audio Port 11 of your headphones and the other end into your phone or plane's 3.5mm socket to start listening to your music or movie. *3.5mm audio cable available separately. ** Note: ANC mode is not available when using a 3.5mm cable to connect the headphones.

Safety Precautions

• Please DO NOT use adapters more than DC5V 1A! Please use the original cable supplied with the package as different cables could harm the product and void its warranty.
• Attention - Magnetic Fields: Magnetic fields are being generated by this product that could cause interference with cardiac pacemaker, implanted defibrilators (ICDs) and other implants. Please always maintain at least 10cm/3.94 inch distance between the headphone and the pacemaker, implanted defibrilators (ICDs) and other implants. Check with your doctor before use if you are fitted with a medical device such as a pacemaker or a programmable shunt!

Safety Precautions for the Batteries:

Do not expose the batteries (battery pack or batteries installed) to excessive heat, such as sunshine, fire or the like, for a long time. Do not subject the batteries to extreme low temperature conditions that may result in overheating and thermal runaway. Do not dismantle, open, or shred secondary cells or batteries. In the event of a cell leaking, do not allow the liquid to come in contact with the skin or eyes. If contact has been made, wash the affected area with copious amounts of water and seek medical advice. Secondary cells and batteries need to be charged before use. Always refer to the manufacturer's instructions or product manual for proper charging instructions. Always dispose of properly.

Notice

1. Keep the product dry; do not place the product in damp places.
2. Keep out of direct sunlight and high temperatures. High temperatures may result in damage.
3. Keep out of cold temperatures, this will help avoid internal damage.
4. Do not disassemble the product.
5. Avoid dropping the product.
6. Do not continue to charge the product over 10 hours.
7. When charging use the Type-C charging cable that came with the product.

Recycle

Disposal of waste batteries and electrical and electronic equipment (applicable in the European Union and other countries with separate collection systems). This symbol on the product, the battery or on the packaging indicates that the product and the battery shall not be treated as household waste. Recycling of materials will help conserve natural resources. Please hand over products at end-of-life to the appropriate collection point for the recycling of electrical and electronic equipment. For all other batteries, please view the section on how to remove the battery from the product safely. Hand the battery over to the appropriate collection point for the recycling of waste batteries.

LET'S BE SAFE

To avoid hearing damage, limit the time you use headphones at high volume and set the volume to a safe level. The louder the volume, the shorter the safe listening time is.

CE Declaration

Hereby GL Grup-2015 LTD declares that wireless headphone PowerLocus Universe is in compliance with essential requirements and other relevant conditions of Directive 2014/53/EU. The full text of the EU declaration conformity is available at the following internet address: (powerlocus.com/doc)

Frequency: 2402-2480 MHz

Max radio frequency power: 100 mW (EIRP)

GL GRUP-2015 LTD. 36 VASIL LEVSKI STREET, 5370 DRYANOVO, BULGARIA

UK Statement of Compliance

Hereby, GL GRUP-2015 LTD. declares that this equipment is in compliance with the UK relevant statutory requirements. To find out more about the UK Declaration of Conformity, please visit: https://powerlocus.com/doc-uk-universe

Aleksandar Glushkov, General Manager

Dryanovo BG, 2024-06-07

Registered Office: GL GRUP-2015 LTD, Vasil Levski 36, Dryanovo 5370, Bulgaria

ISED Canada Statement

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence exempt RSS(s). Operation is subject to the following two conditions: this device may not cause interference and this device must accept any interference, including interference that may cause undesired operation of the device. Radiation Exposure: This equipment complies with Canada radiation Exposure limits set forth for an uncontrolled environment to maintain compliance with IC's RF Exposure guidelines. This equipment should be installed and operated with minimum distance of 0mm the radiator your body. This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter.

Déclaration du Canada

Ce dispositif contient un (S) émetteur (S)/ récepteur (S) exempté (S) de licence qui respecte l'innovation, Science et développement économique Canada a exempté le ou les RSS de licence. L'exploitation est soumise aux deux conditions suivantes: 1) cet appareil ne doit pas causer d'interférences et 2) ce dispositif doit accepter toute interférence, y compris toute interférence pouvant entraîner un fonctionnement indésirable du dispositif. Exposition au rayonnement: cet équipement est conforme au rayonnement Canada Les Limites d'exposition fixées pour un environnement non contrôlé afin de maintenir la conformité avec les lignes directrices d'exposition aux RF d'IC. Cet équipement doit être installé et exploité à une distance minimale de 0mm du radiateur de votre corps. Ce dispositif et ses antennes ne doivent pas être co-localisés ni fonctionner en conjonction avec une autre antenne ou un autre émetteur.