Installation Guide for bouncepad models including: BP-COR-FLP-W, BP-COR-FLP-B, BP-COR-FLP-W Core Flip, BP-COR-FLP-W, Core Flip, Flip
BP-COR-FLP-W
Bouncepad BP-COR-FLP-B
Core Flip Assembly Instructions Tools Required: All tools provided Flat Cable Flip Fixings Kit Tablet Mount Plate Shell Sheet Code: BP-IM-081_REV0 Release Date: 07/08/2024 Copyright 2024 Spotspot Ltd. (T/A Bouncepad) all rights reserved. Confidential, no part of this publication may be reproduced or transmitted in any form without the written permission of the copyright holder. In the Box 4x M4x16mm Buttonhead screw 4x M4 Split Washer 1x T20 Pin Torx Allen Key 1x Case Washer 4x Felt Feet 1x Flip Tool 2x 3mm x 6mm Pan Head Screws 4x M3x10mm Countersunk Screw 1x Cable Clamp 1x T10 Pin Torx Allen Key 1x Cleaning Wipe Fixings List * Due to the modular nature of our product range you may receive additional fixings in the fixings kit M4x16mm Buttonhead screw T20 Pin Torx Allenkey M4 Split Washer Case Washer 1 Remove the End Plates from the Flip using the supplied tool. If wishing to slide your Flip across 2 your mounting surface, apply the supplied Felt Feet as shown. Tighten screw(s) using hand tools, using electric tools may damage your Bouncepad. Attach the Shell to the Flip. Take 3 care to ensure correct & full thread engagement. *Before attaching the Mounting Plate, fully clean the back of the tablet with the provided wipe and allow it to fully dry. FoLraonpdtismcaalpaedhteasbiolne,tporerisesnfitramtliyoannd leave for 72hrs in a 20°C environment before use. Do not reposition. Do not use prior to the 72hrs. Portrait tablet orientation 2x 3mmx6mm Pan Head Screws Cable Clamp T10 Pin Torx Allen Key Landscape Portrait Remove the Mounting Plate adhesive 4 backing. Attach level & centrally to the Tablet back as shown. 5 Attach the Flat Cable to the Tablet with the U-Bend Head. 6 Secure the Flat Cable to the Mounting Plate with the Cable Clamp as shown. Top Fixing Cover 4x M3x10mm Countersunk Screw T10 Pin Torx Allen Key Bottom Fixing Cover Remove the Fixing Covers. Feed the Flat 7 Cable into the assembly & locate the Tablet in the chosen orientation. 8 Secure the Tablet to the Shell & attach the Fixing Covers as shown. Connect the tablet power 9A cable to its mains power source. *the Flip is designed to support the Anker PowerCore 10000mAh. *battery pack is not provided. If installing a battery pack, connect 9B the tablet cable & locate the pack into the Flip. 10 Locate the Flip End Plates onto the Flip Base. 11 Installation is now complete.Adobe PDF Library 17.0 Adobe InDesign 19.5 (Windows)