Smartwares SH4-99558 Wireless Built-in Up/Down Switch + Remote
Model Numbers: SH4-99558, SH5-90150
Specifications:
- SH5-90150: Battery: 3VDC, type CR2032 (included), Max RF Output: 0dBm, Frequency: 433.92 MHz
- SH4-90259: Max Range: 50m, Max Power: 300W, Max RF Output: 0dBm, Frequency: 433.92 MHz
Manufacturer: Smartwares, Jules Verneweg 87, 5015 BH Tilburg, The Netherlands
Website: www.smartwares.eu
Instructions for Use
Preparation Before Use
Please read the operating instructions and observe all warning and safety notes.
- Locate the circuit breaker for the wall switch you will be working on in your electrical circuit panel.
- Switch off the circuit.
Connecting the Receiver to the Power Supply
(1) Connect the phase wire (brown) to L and the neutral wire (blue) to N.
Connecting the Receiver to the Roll-Down Shutter Motor (Standard Connection)
(2) Consult the motor's instruction manual before connecting.
- Connect the "UP/OPEN" pin of the motor to B and the "DOWN/CLOSE" pin of the motor to A.
- Connect the phase wire of the motor (black) with C.
NOTE: For correct connections of a potential-free contact, consult the manual of the gate or garage door motor.
Mounting the Receiver
(3) Mount the receiver in place of the existing up/down switch. Switch on the power using the power switch in your electrical circuit panel.
Pairing
Pairing the receiver with a sender:
- Press and hold the button on the receiver for 3 seconds, then release it (5). The LED will start blinking, indicating the receiver is in pairing mode. Attention: The LED should only blink after releasing the button. If it blinks while holding the button, pairing will not occur.
- Press the "PAIR" button on the sender for 2 seconds to pair it with a receiver. The LED on the receiver will light up, and the LED on the sender will blink rapidly.
Your receiver and sender are now paired.
Attention: A receiver can be paired with multiple senders; eight memory positions are available.
Setting a Timer on the Receiver
Timer Modes:
- Short press the button on the receiver once.
- Then, press and hold the button on the receiver for 3 seconds and release it.
- There are 4 modes: A, B, C, D. The factory setting is mode A.
- Press the "I/ON" button on the sender to cycle through modes: B > C > D. Press the "O/OFF" button on the sender to cycle backwards: D > C > B > A.
- To set the desired mode, press the learning button for 3 seconds. The LED will turn on continuously to confirm the set mode.
| Mode | Receiver Turns Off | LED Blinks | Use |
|---|---|---|---|
| A | Manual up/down | 1x | Shutters |
| B | Close/down after 1 sec | 2x | Electric garage door/gate |
| C | Close/down after 5 sec | 3x | Door opener |
| D | Close/down after 120 sec | 4x | Lighting |
NOTE: The program mode lasts for 10 seconds. If the receiver does not receive a signal from a sender within this period, the program mode will stop.
Operating Receivers
- Press the "I/ON" button on the sender to activate the receiver.
- Press the "O/OFF" button on the sender to turn off the receiver.
Disconnecting All Links
- When the switch is connected to the power supply, press and hold the button on the built-in switch for 6 seconds, then release it.
- The LED starts to blink quickly for 12 seconds.
- During this period, press the button again. The LED will start to blink slowly, then stops blinking and is constantly lit.
- All links will be disconnected.
