Q SMART HOME LIGHTS

3 | Pairing the Remote Control

Follow these steps to pair your Q-remote control with the Q-receiver (lamp).

Refer to the Q-remote control manual.

Resetting the Lamp to Factory Settings:

1. Switch on the lamp ?.
2. Perform 5 on/off cycles (5 x on/off).

Teaching the Q-Remote Control:

1. Read the instruction manual.
2. Press buttons on the remote control.
3. Pairing sequence: Apply power for 5-10 seconds, then press remote buttons with 1-2 second intervals.

Diagram Description: The diagram illustrates a Q-receiver (antenna) connected to a lamp. A separate Q-remote control is shown. The reset process involves cycling the lamp's power 5 times. The pairing process involves specific button presses on the remote control after the lamp is powered for a short duration.

1 | Technical Specifications (Model 832184)

• Power Supply: 230V/50Hz
• Light Source: LED
• LED Board: 3x 18W LED-Board (not changeable)
• Luminous Flux: 18W (2,200 lm), 60W (2,900 lm)
• LED Lifespan: 25,000 hours
• Color Temperature: 2,700-5,000 K
• Switching Cycles: 15,000x
• Response Time: < 0.5 seconds
• Dimmability: Dimmable with RRC (Radio Remote Control)
• Included: Radio remote control (requires AAA, 1.5V batteries - not included).

2 | Montage / Fitting

This product is designed for use as a ceiling light.

Diagram Description: The diagram shows the fixture being mounted. It indicates a required hole diameter of 6mm for installation.

3 | Elektrischer Anschluss / Electrical Connection

230 Volt / 50 Hz Connection:

Diagram Description: The diagram illustrates the electrical wiring for the fixture. It shows the connection points for the mains power supply. Terminal 'a' should be connected to the Neutral (N) wire, and terminal 'b' should be connected to the Live (L) wire of the 230V AC power source.

Declaration of Conformity

This device fulfills the fundamental requirements of Directive 2014/53/EU (Radio Equipment Directive) of the European Parliament and of the Council of the European Union dated 16.04.2014 on items of radio equipment and the mutual recognition of their conformity.

The full declaration of conformity can be requested from the address given below.