myQ Remote Control Product Manual

Overview

This manual details the operation of myQ 2-Button Keychain and 3-Button Remote Controls. These remotes are compatible with Chamberlain®, LiftMaster®, and Craftsman® garage door openers manufactured after 1997 (excluding Craftsman Series 100). Each remote can be programmed to control up to three or two garage door openers, respectively, with each button functioning independently. Images in this guide are for illustrative purposes and may differ from the actual product.

To prevent potential serious injury or death from a moving gate or garage door:

• Keep remote controls out of children's reach.
• Never allow children to operate or play with remote transmitters.
• Activate gates or doors only when clearly visible, properly adjusted, and free of obstructions.
• Always keep gates or doors in sight until fully closed.
• Never allow anyone to cross the path of a moving gate or door.

WARNING: This product can expose you to chemicals including lead, which are known to the State of California to cause cancer or birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

Programming the Remote

Follow the instructions below to program your myQ remote control. Ensure your garage door opener has a working light, which is necessary for the programming process. Refer to the specific LEARN button color on your garage door opener for detailed instructions.

Important: Locate and identify the color of your garage door opener's LEARN button. A ladder and possibly removing a light cover may be required.

Programming Options:

• Using the myQ app: Connect your garage door opener to the myQ app for advanced features like remote naming and notifications.
• Using the LEARN button: Follow the specific steps based on the color of your garage door opener's LEARN button (White, Yellow, Purple/Brown, Orange, or Red).
• Using the Control Panel: Utilize your garage door opener's control panel for programming.

General Programming Steps (for Yellow, Purple, Orange, or Red LEARN Button):

1. Press and hold the two smaller buttons on the remote simultaneously until the red LED stays on.
2. Press and immediately release the LEARN button on your garage door opener.
3. Within 20 seconds, press and release the desired remote button twice. The remote's red LED will flash intermittently.
4. When your garage door moves, within 3 seconds, press and release any remote button to confirm.

General Programming Steps (for White LEARN Button):

1. Press and immediately release the LEARN button on your garage door opener.
2. Within 30 seconds, press and hold the remote button you wish to program. Release when the garage door opener lights flash and/or two clicks are heard.

Testing: Press the programmed remote button. The garage door opener should activate. If it does not, wait for the opener's LEARN button LED to turn off (up to 3 minutes) and repeat the programming steps.

Troubleshooting: If programming issues arise, especially when switching between different colored LEARN buttons, refer to page 5 of the manual for specific instructions.

Replacing the Battery: 3-Button Remote Control

When the LED on your remote control stops flashing, the battery needs replacement. Use only a 3V CR2032 coin cell battery. Dispose of the old battery properly.

1. On the back of the remote, unscrew the captive screw with a Phillips #1 screwdriver.
2. With the remote buttons facing up, pry open the top housing from the bottom housing.
3. Use a cotton swab to push the old battery out of its holder.
4. Insert the new CR2032 battery with the positive side up.
5. Align the top and bottom housing and clip them together. Tighten the captive screw until the housing is secure, being careful not to overtighten.