ASRock Regulatory Notices

FCC Compliance Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Button Battery Safety Notice

Remove and immediately recycle or dispose of used batteries according to local regulations and keep away from children. Do NOT dispose of batteries in household trash or incinerate. Even used batteries may cause severe injury or death. Call a local poison control center for treatment information.

• Battery type: CR2032
• Battery voltage: 3V
• Non-rechargeable batteries are not to be recharged.
• Do not force discharge, recharge, disassemble, heat above (manufacturer's specified temperature rating) or incinerate. Doing so may result in injury due to venting, leakage or explosion resulting in chemical burns.
• This product contains an irreplaceable battery.
• This icon ? indicates that a swallowed button battery can cause serious injury or death. Please keep batteries out of sight or reach of children.

California, USA ONLY

The Lithium battery adopted on this motherboard contains Perchlorate, a toxic substance controlled in Perchlorate Best Management Practices (BMP) regulations passed by the California Legislature. When you discard the Lithium battery in California, USA, please follow the related regulations in advance.

"Perchlorate Material-special handling may apply, see www.dtsc.ca.gov/hazardouswaste/perchlorate"

? WARNING: Risk of cancer and reproductive harm from exposure to Lead. See www.P65Warnings.ca.gov

CE Conformity

CE

ASRock INC. hereby declares that this device is in compliance with the essential requirements and other relevant provisions of related Directives. Full text of EU declaration of conformity is available at: http://www.asrock.com

ASRock follows the green design concept to design and manufacture our products, and makes sure that each stage of the product life cycle of ASRock product is in line with global environmental regulations. In addition, ASRock disclose the relevant information based on regulation requirements.

Please refer to https://www.asrock.com/general/about.asp?cat=Responsibility for information disclosure based on regulation requirements ASRock is complied with.

UKCA Conformity

UK CA

ASRock INC. hereby declares that this device is in compliance with the essential requirements and other relevant provisions of related UKCA Directives. Full text of UKCA declaration of conformity is available at: http://www.asrock.com

Consumer Limited Warranty - Australia

Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage caused by our goods. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. If you require assistance please call ASRock Tel : +886-2-28965588 ext.123 (Standard International call charges apply)

Proper Disposal

? DO NOT throw the motherboard in municipal waste. This product has been designed to enable proper reuse of parts and recycling. This symbol of the crossed out wheeled bin indicates that the product (electrical and electronic equipment) should not be placed in municipal waste. Check local regulations for disposal of electronic products.

Class B ITE

この装置は、クラスB情報技術装置です。この装置は、家庭環境で使用することを目的としています が、この装置がラジオやテレビジョン受信機に近接して使用されると、受信障害を引き起こすこと があります。取扱説明書に従って正しい取り扱いをして下さい。

Trademark Information

The terms HDMI® and HDMI High-Definition Multimedia Interface, and the HDMI logo are trademarks or registered trademarks of HDMI Licensing LLC in the United States and other countries.

HDMI HIGH-DEFINITION MULTIMEDIA INTERFACE ®

BSMI Limited Use of Hazardous Substances List

Note 1: "Exceeds 0.1 wt%" and "Exceeds 0.01 wt%" refer to the percentage content of the restricted substance exceeding the percentage content threshold.

Note 2: "○" indicates that the percentage content of the restricted substance in this item does not exceed the percentage content threshold.

Note 3: "-" indicates that this restricted substance is excluded.

China RoHS

Electronic Information Products Pollution Control Marking

According to China's "Requirements for the Restriction of Hazardous Substances in Electronic Information Products" and SJ/T 11364-2024 "Requirements for Marking of Hazardous Substances in Electrical and Electronic Products", electronic information products should be marked to inform consumers about the period during which toxic or hazardous substances or elements contained in the product will not leak or mutate, thereby causing environmental pollution or serious harm to personal or property safety. According to the above regulations, you can see the marking in Figure 1 on the printed circuit board of this product. The number in Figure 1 is the environmental protection use period of the product.

10

Figure 1

Information on Hazardous Substances in Products

The above table is compiled in accordance with the provisions of SJ/T 11364-2024.

Note 1: ○: Indicates that the content of this hazardous substance in all homogeneous materials of this component meets the national standard requirements for the restriction of hazardous substances in electronic information products.

Note 2: X: Indicates that the content of this hazardous substance in at least one homogeneous material of this component does not meet the national standard requirements for the restriction of hazardous substances in electronic information products.

Note 3: For components not listed above, it indicates that the hazardous substance content meets the national standard requirements for the restriction of hazardous substances in electronic information products.

Note 4: The environmental protection use period indicated for this product refers to normal use.