User Manual for MiraScreen models including: G130RX, 2ALU5-G130RX, 2ALU5G130RX, G130RX Wireless Presentation Receiver, Wireless Presentation Receiver, Presentation Receiver
TeVii Technology Co.,Ltd. G130RX Wireless Presentation Receiver 2ALU5-G130RX 2ALU5G130RX g130rx
Size:100*57mm , MiraScreen , ! HD -RX USB-C HD VGA 3.5mm -TX Ver. A 1.0 USB-C USB-C USB-C , USB-C [RX] - [TX] - Preface Thank you for purchasing the MiraScreen products, For optimum operation, please read this manual carefully before use. MiraScreen MiraScreen MiraScreen MiraScreen Wireless HD Transmitter & Receiver Kit User manual Receiver-RX Indicator Light Function Button USB-C Power Supply Port HD VGA 3.5mm Jack ON-OFF Switch Transmitter-TX Ver. A 1.0 Function HD Button Indicator Light USB-C Power Supply Port Connect the HD port or VGA port of the receiver to the video input port of the display device such as the monitor or TV. Connect the USB-C power supply port of the receiver to the charging cable and plug it into the power adapter ( Voltage above 5V, current above 2A). Turn on the Receiver power switch. Adjust the HD Signal source of the monitor or TV to the corresponding HD port untithe boot screen is displayed. Connect the transmitter to the computer or other devices With HD video output function . After the indicator Light enters the fast flash state , Wait for ten seconds to complete Casting. *Please make sure that the power of the computer is sufficient. If the power supply of the computer is insufficient or HD is unable to supply power , please connect the transmitter to the power adapter or USB-C power supply port ( Voltage above 5V , current above 2A ) Receiver[RX] - Function Button Transmitter[TX] - Function Button MiraScreen Please Press the receiver function button for more than 3 seconds, and the prompt will pop up on the interface : Release the button to pair With Ezcast TX. Wait for the transmitter to enter pairing mode Press the transmitter function button for more than 3 seconds , the indicator will flash for pairing , and Wait for the transmitter indicator to be always on, indicating that the connection is successful. MiraScreen FCC Warning Statement Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. RF Exposure Statement To maintain compliance with FCC's RF Exposure guidelines, This equipment should be installed and operated with minimum distance of 20cm the radiator your body. This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter.Adobe PDF library 15.00 Adobe Illustrator(R) 17.0