Self-Cleaning Litter Box

1. Unpack Components

Unpack the following items: LitterMaid™ litter box, AC adapter (in styrofoam packaging), disposable waste receptacles, LitterMaid™ triple-action tool, use and care book, cleaning brush (packed with disposable waste receptacles), and any optional items such as carbon filters, paw-cleaning ramp, cat-privacy tent, and litter box carpet.

2. Prepare Rake and Compartments

2a. Cut and remove the restraints located on each end of the rake.

2b. Peel off the protective tape from the waste receptacle compartment cover and the battery compartment. Remove any styrofoam from the top of the rake.

Note: The unit comes with an initial waste receptacle installed.

3. Install Waste Receptacle

3a. Place a disposable waste receptacle under the waste receptacle compartment cover. Ensure the front of the waste receptacle is positioned under the five tabs. There should be no gap between the unit and the waste receptacle.

3b. Attach the waste receptacle lid by inserting the push-tabs into the round holes. Secure the lid by pressing on the indicated positions.

3c. If carbon filters are included: Peel off the paper strip on the carbon filter to expose the adhesive. Place the filter adhesive-side down into the diamond-shaped insert located in the center of the waste receptacle lid. Close the waste receptacle compartment cover.

4. Fill with Litter

Use only premium clumping litter. Do not use non-clumping litter, crystal, or pearl-like litters. Fill the LitterMaid™ litter box to just below the "Full Line" indicator.

[Fill Line Indicator]

5. Check Litter Level

Use the LitterMaid™ triple-action tool to verify that the litter is at the correct level in the center of the unit. Do not overfill the unit, as this may prevent proper operation.

6. Connect Power and Start

6a. Remove the AC adapter from its styrofoam packaging and plug it into the unit.

6b. Plug the adapter cord into a standard electrical wall outlet.

6c. Turn the On/Off switch to the "on" position. A red indicator light will appear.

6d. The rake will automatically initiate its first cleaning cycle, smoothing out the litter. Your LitterMaid™ is now ready for use!

Troubleshooting and Acclimation

For troubleshooting assistance, refer to the "Troubleshooting" section in the use and care book (page 6).

To help your cat adjust to the LitterMaid™ litter box, consult the "Acclimating Your Cat" section in the use and care book (page 5).

Optional Items

For more information, call Toll-Free: 1-800-LITMAID (548-6243) or visit our website: www.littermaid.com.

Litter Box Carpet

Place the unit on the litter box carpet.

Cat Paw-Cleaning Ramp

7a. The paw-cleaning ramp features two pivot pins designed to snap into holes on the side of the waste receptacle compartment cover. Position the paw-cleaning ramp with the carpeted side facing upwards.

7b. Align the pivot pins with the holes located at the disposable waste receptacle end of the unit. Lift the paw-cleaning ramp and insert one of the pivot pins into a hole.

7c. Gently stretch the other pivot pin to reach the adjacent hole, then insert it. Lightly tug on the paw-cleaning ramp to confirm it is securely in place.

Tent

Assemble the tent to cover the unit. Refer to the separate instruction sheet for details.

Removing Disposable Waste Receptacle

It is recommended to avoid direct contact with waste material. Wear rubber or latex gloves when handling a used disposable waste receptacle.

8a. Press the two push-tabs located on the waste receptacle compartment cover. Detach the disposable waste receptacle lid from the main compartment cover.

8b. Lift the compartment cover to expose the closed disposable waste receptacle assembly.

8c. Pull the edge of the disposable waste receptacle free from the tabs that hold it in place.

8d. To dispose of the waste receptacle, press in on all four corners of the lid to secure it to the receptacle, then dispose of the unit.