FAGOR Stand Mixer 2in1
Model: FG1563 - FG5286
Instruction Manual
Introduction
Read this manual thoroughly before using and save it for future reference.
Technical Specifications
| Model | FG1563 - FG5286 |
|---|---|
| Rated voltage | 220-240V~ |
| Frequency | 50-60 Hz |
| Power consumption | 1500W |
| Protection class | II |
General Safety Instructions
Before putting the appliance into operation, read the operating instructions carefully and keep them, including the warranty, receipt, and, if possible, the original packaging. If you give this device to others, please also pass on the operating instructions.
- The appliance is designed exclusively for private use and for its intended purpose. It is not suitable for commercial use.
- Do not use it outdoors unless specifically designed for outdoor use.
- Keep it away from heat sources, direct sunlight, humidity (never immerse in liquid), and sharp edges.
- Do not handle the appliance with wet hands. If the appliance is humid or wet, unplug it immediately.
- Always unplug the appliance from the power outlet (pull the plug, not the cable) when not in use and remove attached accessories.
- Do not operate the appliance without supervision. Always switch off the appliance or unplug it if you need to leave the workspace.
- Regularly check the appliance and cable for damage. Do not use if damaged; contact an authorized technician for repairs. If the power cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly qualified persons to avoid hazards.
- Use only original spare parts.
- Pay careful attention to the following "Special Safety Instructions".
Children and Frail Individuals
- To ensure children's safety, keep all packaging (plastic bags, boxes, polystyrene, etc.) out of their reach.
- Caution! Do not allow small children to play with the foil packaging as there is a danger of suffocation!
- This appliance shall not be used by children. Keep the appliance and its cord out of reach of children.
- Appliances can be used by persons with reduced physical, sensory, or mental capabilities or lack of experience and knowledge if they are supervised or have received instructions on safe use and understand the potential hazards.
Special Safety Instructions for this Machine
- Always disconnect the appliance from the power supply if it is left unattended and before assembling, disassembling, or cleaning.
- Switch off the appliance and disconnect from the supply before changing accessories or approaching parts that move during operation. Do not use the appliance for purposes other than intended.
- CAUTION: To avoid hazards due to inadvertent resetting of the thermal cut-out, this appliance must not be supplied through an external switching device (like a timer) or connected to a circuit that is regularly switched on and off by the utility.
- Do not interfere with any safety switches.
- Do not insert anything into the rotating hooks while the machine is working.
- Place the machine on a smooth, flat, and stable working surface.
- Do not insert the mains plug into the power socket without having installed all necessary accessories.
- CAUTION: Ensure that the mixer is switched off before removing it from the stand.
Name of Different Parts
The FAGOR Stand Mixer features a main unit with a motor housing, a control dial, and a lift mechanism. It comes with various accessories for different mixing tasks.
Main Parts and Standard Parts:
| Part No. | Description |
|---|---|
| 1 | Output shaft |
| 2 | Rise button |
| 3 | Speed button |
| 4-1 | 4.3L bowl |
| 4-2 | 3.7L bowl |
| 5 | Dough hook |
| 6 | Beater |
| 7 | Whisk |
| 8 | Bowl cover |
Multifunctional Pot Cover Function Introduction
The multifunctional pot cover includes several integrated tools:
- Measuring cup: Measures auxiliary ingredients for food preparation in small doses.
- Fitting hole: Used for cleaning accessories and temporary airing.
- Light trough: A mobile light source to assist lighting and observe changes within the pot.
- Separator: Easily separates egg whites and yolks.
- Face cutter: Cuts kneaded dough.
- Toothed cutter: Cuts hard foods and accessories.
- Convex mirror: Provides a magnifying effect.
- Measuring stick: Measures dimensions.
How to Use the Machine
- Before use, wash accessories with clean water, rinse, and dry them.
- Place the machine on a flat, clean, and dry table. Press the head-up button (2) on the fuselage to automatically lift the machine head.
- Weigh ingredients and water into the mixing bowl (4). Assemble the bowl onto the machine, turning clockwise until it locks. Do not exceed the maximum total dough weight.
- Install the required accessory (5, 6, or 7 – only one at a time) onto the output shaft (1). Align the slot and push the accessory until it clicks into place.
- Place the pot cover into the designated stirring end of the machine.
- Press the machine head down; it will automatically lock with the head button (2).
- Plug in the appliance and turn on the power switch.
- Set the speed control knob (3) to the desired speed to start mixing.
- Once the dough reaches the desired consistency, turn the speed knob (3) back to position 0 to stop.
- To remove the dough: Press the head-up knob (2) with your hand, lift the upper body, turn the mixing bowl counterclockwise, remove the bowl, and then remove the dough.
- Switch off the appliance and disconnect from the power supply before changing accessories or approaching moving parts.
Usage Steps Visual Guide: The manual illustrates six steps (FG1-FG6) showing the sequence of operations: lifting the head, attaching the bowl, attaching an accessory, adding the bowl cover, locking the head, and plugging in/operating.
Suggestion: Adjusting Levels and Usage
Recommendations for using accessories with mixtures up to 1.5kg:
| Accessories | Speed | Time (min) | Maximum | Operation Method |
|---|---|---|---|---|
| Dough hook | 1-6 | 3-5 | 600g flour + 322g water | Speed 1 for 30s, Speed 2 for 30s, then Speed 3 for 2 to 4 minutes to form a dough. |
| Beater | 1-7 | 3-10 | 660g flour + 840g water | Speed 2 for 20s, then Speed 4 for more than 2 minutes 40 seconds. |
| Whisk | 8-10 | 3-10 | 3 egg whites (min) | Use Speed 5 or 6 for 3 minutes. |
Analysis of Common Problems
| Phenomena | Causes | Solutions |
|---|---|---|
| Machine suddenly stops working during use. | Machine may have run too long, ambient temperature too high, causing motor overheating and activating protection program. | Reset speed to "0", unplug, wait for the machine to return to room temperature (approx. 15-30 minutes) before restarting. |
| Machine does not run when turning the knob. | Check if the plug is properly connected to the socket. Check if the power is out. Check if the rise button is in place. | Verify the power plug is plugged into the outlet. Wait for power before operating. Make sure the headstock is stuck in place. |
| Excessive noise when the machine is running. | Machine works louder in high gear than low gear. Amount of food stirred is too large (overloading). Voltage is unstable. Working time is too long. | Choose the appropriate gear for the food. Reduce the amount of food. If voltage is unstable, wait for it to stabilize. If working time is too long, stop and cool down. |
| Machine speed drops or is unstable. | Room temperature is low, causing lubricant to harden. Ingredients are too hard/numerous, overloading the machine. Voltage suddenly becomes low. | Remove the mixing bowl and let the machine idle for 5 minutes to soften lubricant and restore speed stability. Reduce mixing volume and work within normal load. Wait for stable voltage. |
| Machine swaying and shaking when working. | Check if the foot pad on the base is off. Machine is not placed on a smooth, flat countertop. | Ensure foot pad is on the base. Place the appliance on a smooth, flat countertop. |
| Headstock cannot reset after putting on anti-splash cover and mixing bowl. | Check that the anti-splash cover is in place and the mixing bowl is assembled. | Rotate the anti-splash cover and assemble it in place, then assemble the mixing bowl. |
| Dough darkening found after use. | Black powder falls onto the dough at the mixing head. | Please check that the mixing head and hook are dry and that no water or dust is present on the surface before use. |
Cleaning
Body Cleaning:
- Do not immerse the machine in water. Do not shower water directly on top of the machine to prevent water from entering the body, which could cause short circuits, electric shock, leakage, rust, or other failures.
- Do not use a damp towel to wipe the machine.
- Do not use detergent, vinegar, salt, or other corrosive, strongly acidic, or strongly alkaline cleaning products on the machine body, as this can damage its surface.
- Do not use sharp or rough tools, such as wire balls, to brush accessories, as this can damage their surface.
Accessory Cleaning:
- Do not put cast aluminum parts into the dishwasher or wash them with corrosive, strongly acidic, or alkaline cleaning products. (Exception: stainless steel parts, surface-treated Teflon parts, and electrophoresis parts may be dishwasher safe).
- Do not soak accessories for a long time in detergent, saltwater, vinegar, or other corrosive liquids; clean them promptly.
- After cleaning, dry accessories thoroughly, especially internal parts.
Special Cleaning:
- The rotating output shaft may produce black traces due to high speed and friction during operation. Clean it promptly after each use and keep it dry.
- Pay attention to sharp blades and accessories with sharp edges.
Preservation and Maintenance:
- You can apply olive oil to the blade's surface, knife plate, and mixing pot to ensure a dry environment and prevent oxidation.
- When not in use, cover the machine with a packaging bag and place it in a dry environment.
Removal of Appliances Used (WEEE)
Directive 2012/19/EU on waste electrical and electronic equipment (WEEE) requires that appliances are not disposed of with normal municipal waste. Old appliances must be collected separately to optimize recovery and recycling of materials and reduce environmental impact. The dustbin symbol reminds consumers of separate collection obligations. Contact local authorities or dealers for disposal steps. If scrapping an old appliance, render dangerous parts harmless by disconnecting the power cable.
Danger:
- Never attempt to use a damaged appliance or one with a damaged power cord or plug. If the power cord is defective, it must be replaced by after-sales service to eliminate danger.
- Only qualified and authorized persons should repair the appliance. Non-standard repairs can significantly increase user risk.
- Defects from improper handling, degradation, or third-party repairs void the warranty. This also applies to normal wear and tear of accessories.
Important!
It is recommended to keep the original packaging for at least the duration of the warranty. The guarantee is not valid without original packaging.
Warranty:
Your device has a two-year warranty. Accessories and spare parts are available only during the warranty period. The warranty does not cover wear, breakage from misuse, or damage from improper handling. The customer is responsible for all returns, including shipping costs and risks. Ship products with acknowledgement of receipt and transport insurance for valuable items.
KEEP OUT OF REACH OF CHILDREN: Children should be supervised to ensure they do not play with the appliance.
Service Email: relations.clients@euromenage.com
Manufacturer Information
FAGOR EUROMENAGE
20/22 Rue de la ferme saint ladre
95470 SAINT WITZ, FRANCE
CE Mark
