Uline H-6306, H-6307, H-7031 Sit/Stand Desktop Riser

Tools Needed

Phillips Screwdriver ?

Parts

• Desktop x 1
• Keyboard Tray x 1
• Left Connecting Plate x 1
• Right Connecting Plate x 1
• Cover x 2
• Screw x 8
• Cable Tie x 4

Assembly

1. Set the desktop on a large surface to prevent falling or tipping. Extend to full height by pushing up on the paddle on the right side. (See Figure 1)
   NOTE: It is recommended that two people move the desktop.
   CAUTION! Do not place hands near the support bars, as they change position during adjustment. Doing so may cause bodily harm.
2. Place covers onto the connecting arms. (See Figure 2)
3. Flip keyboard tray upside down. Insert connecting plates and fasten to keyboard tray using eight screws. (See Figure 3)
4. Hang connecting plates onto the four knobs located underneath the desktop and turn knobs clockwise to fasten the keyboard tray. (See Figure 4)
5. Place devices onto the desktop. Use supplied cable ties to fasten cables. (See Figure 5)
   CAUTION! Do not place equipment on edges of desktop.
   CAUTION! Leave enough cable length for height adjustment functions.

Contact

For assistance, please contact Uline at 1-800-295-5510 or visit uline.com.