Instruction Manual for STARK models including: ST-36 Wireless SOS Button, ST-36, Wireless SOS Button, SOS Button, Button
File Info : application/pdf, 2 Pages, 818.27KB
DocumentDocumentSTARK
OPERATING MANUAL
Wireless SOS Button ST-36
>CONTENTS
The wireless SOS button with low power consumption and high stability. Ultra-low power consumption design, with a long service life, on-site alarm prompt sound, battery low power prompt function, battery low power report to alarm host function. This product is suitable for all kinds of old-age care institutions, hospitals and families. When the elderly feel unwell or other emergency, you can pull the emergency rope or press the emergency button.
>Technical Specifications
· Working voltage: DC 3V(2pcs 1.SV/AA) · Standby current: sSuA · Alarming current: sSOmA · Wireless frequency: 433.92MHz · Wireless range: >300meter{open area) · Working Temperature: -10°C-+50°C · Working humidity: !5:80% (no condensation)
e
SCHEMATIC DIAGRAM OF FRONT COVER
Indicator Light
r+-+-- -SOS Button
SCHEMATIC DIAGRAM OF BOTTOM BOX
Buzzer
f)
> Feature
· Micro power consum ption design ·Double use of SOS pull and SOS button · Battery low power prompt · Battery low power report to alarm host · The scene sound and light pr ompt when alarm ·Automatic detection of new andold battery
loading prom pt function
> Instructions
Power ON
When the battery is powered on, the
emergency button will check whether the
battery is old or new. When the battery voltage is lower than 2.4V,
it is an old batte ry, and the g reen tig ht 1 time
fl ashed . When the installed battery voltage is more
than time
f2la. 4sVh, eitd,isaanndeawlsobawttieth
ry, th e send
red light "battery
1
restore" report toalarm host.
)
Battery Detection
To ensure that wireless products can work normally, if the emergency button flashes green light 1 times in each 50 seconds (accompanied with 1 sound of "Di") or when the low power report reminds the host means the battery voltage is insufficient, please replace the battery timely.
Alarming
Alarm will be triggered when the emergency rope is pulled orthe emergency button is pressed. At this time, the red light will flash quickly and the buzzer will give an alarm for 15 seconds. If the user wants to turn off the alarm quickly, pull the emergency cord or press the emergency button again.
> Installation
· Open the cover of the emergency button, remove the battery insulation, will auto enter the working state immediate ly.
· Install the emergency button into the spec ified position by double-sided tape or screws.
0
Wall Cartridge
Front Cover
Installation Method 1
I!
Installation Method 2
· 3M pasteraffixed to the back of the installation box.
· Wipe clean where installation is needed, and affix the installation box.
Note: In order to ensure the reliable operation of the system. users need to test the system regularly. Ifany problem Is found during the test, please consult relevant personnel Immediately to solve it.
0