User Manual for CRYSTAL VIDEO models including: CRYSTAL VIDEO, Wireless, Video Link, PRO 800, CC8980, CC3865
CVW Crystal Video Pro 800 Videofunk Set ► günstig kaufen bei Huss Licht & Ton
File Info : application/pdf, 12 Pages, 5.45MB
DocumentDocumentUser Manual Version:1.3 Contents About the User Manual 02 Brief Introduction 02 Features 02 Packing List 03 Specification 04 Structure & Interface 05 Wireless HD Transmitter:CC8980 05 Wireless HD Receiver:CC3865 07 Product Installation 09 Wireless HD Transmitter:CC8980 09 Wireless HD Receiver:CC3865 12 OLED Display Description 14 Support Full PSF Resolution 16 Antenna Installation Recommendations 17 Trouble Shooting 20 About the User Manual Compatible EDID 1.1, Support HDMI 1.3 2-pin Lemo to DTap 2-pin Lemo to DTap ATC_VITC ATC_LTC -10 ~ 50 -10 ~ 50 Product Installation OLED Display Description Sound Mode:mode 0,display nothing, mode 1 display melody logo. Support Full PSF Resolution Support Full PSF Resolution 25PSF in = 25PSF out Gain state:H/L: "L" is low-gain mode,application for short distance transmission, good ability to anti-jamming; "H" is high-gain mode,application for long distance transmission, normal ability to anti-jamming; Wireless Video Connect: When connection failed ,displays nothing; When connection normally,displays"VIDEO" Antenna Installation Recommendations In order to get the best wireless communication quality and achieve the best transmission effec, the installation of the device should meet the following requirements. a. It is necessary to install transmitter and receiver at least 1.5 meters above groud. the height of receiver and transmitter should be conistent. b. There is no barrier between transmitter and receiver c. The plane of transmitter antennas toward the plane of receiver antennas face-to-face, not vertical or oversized. Recommended Installation Method under Ideal Position Make receiver to stand vertically; adjust antennas to a fan-shaped arrangement; Make transmitter to stand vertically; adjust antennas to 90°angle in the same plane The plane of transmitter antennas toward the plane of receiver antennas face-to-face Recommended Installation Method under Non-ideal Position When the front side of the transmitter is not able to face to the receiver, please try to adjust the direction of transmitter antennas to make sure that the formative fan-shaped arrangement can face to the receiver for best signal transmission. As shown in the diagram 1 and diagram 2 (diagram 1) (diagram 2) Because TX and RX are working on ISM band,wireless transmission performance is relevant with level of interference intensity.If transmission performance declines,we recommend to switch the wireless channel of TX and RX simultaneously for improvement of transmission performance.CorelDRAW 3-Heights™ PDF Optimization Shell 6.3.1.5 (http://www -tools.com)