User Guide for tp-link models including: Tapo T100 Smart Motion Sensor, Tapo T100, Smart Motion Sensor, Motion Sensor, Sensor
Tapo Smart Motion Sensor, Flexible Sensitivity Control, Magnetic Mounting, Battery included, Easy Installation, Work with Alexa, Hub Required separately (Tapo T100), White :
otion 1. Pull up the clip on the back. Then twist the cover anticlockwise with your other hand to remove the cover. 2. Remove the battery insulation tab to power up your sensor if you use it for the first time. 3. Use a pin to press and hold the Reset button for about 3 seconds until the front LED starts blinking. 4. Open the Tapo app, tap + on the upper right corner, and follow app instructions to complete pairing; or press the SYNC button on your Tapo hub to start pairing. After pairing is complete, you can find your device on the home page of the Tapo app. Note: If your device is mounted on the wall with 3M adhesive, please remove the main body from the mounting bracket first. 1. Pull up the clip on the back. Then twist the cover anticlockwise with your other hand to remove the cover. 2. Remove the old battery. 3. Insert the new battery into the battery compartment, making sure the battery is level and its positive side is facing up. 4. Put the cover back on the device. Method 1: 1. Open the Tapo app and tap your device card on the home page to enter the status page. 2. On the status page, you can check all activities of your device. Method 2: Open the Tapo app and tap the email icon on the top right to check all activities of your device. motion sensitivity. 1. Open the Tapo app and tap your sensor card on the home page. 2. Tap the gear icon on the top right to enter the Settings page. 3. Tap Motion Sensitivity to adjust the sensitivity as needed. Increased sensitivity results in more triggered events and notifications; lower sensitivity results in fewer triggered events and notifications.Microsoft: Print To PDF