Installation Guide for Solar Lighting DiRECT models including: SLDWW-3W, SLDWW-3W 3W Wall Washer, SLDWW-3W, 3W Wall Washer, Wall Washer
3W Wall Washer – Solar Lighting Direct
File Info : application/pdf, 1 Pages, 279.99KB
DocumentDocumentINSTRUCTION GUIDE Commercial Wall Washer Model No. SLDWW-3W FEATURES 1. 1 x Light fixture FEATURES 1. Automatic Day/Night Operation 2. Adjustable LED Tube and Bracket 3. 2 Lighting Modes; Mode 1 - 100% brightness for 6 hours than 15% brightness until dawn Mode 2 - 100% brightness for 5 hours than 15% brightness for 6 hours 4. Surface Mounted Base INSTALLATION METHOD 1. Remove contents from packaging and if applicable remove film from solar panel. 2. Switch your light fitting "ON" by pressing the "ON/OFF" button for 3 seconds, to turn "OFF" repeat this 3 second press and your light will switch off. NOTE: Before continuing, we recommend you put your light in direct sunlight (with the switch in the "OFF" position) for 2 days before installation. 3. Decide where to mount your light fitting (Please remember to choose a location where your light will be exposed to a minimum of 6hrs direct sunlight each day) 4. Using 4 screws, fix the surface mounted bases in your desired location. 5. To adjust the direction of the lamp, simply unscrew the Torx screws on each side of the fitting and adjust the light within 90 degree in your desired direction. Once you have chosen your light angle, re-tighten the Torx screws. LIGHT MODES Mode 1 - 100% Brightness for 6 Hours, then 15% Brightness until dawn Mode 2 - 100% Brightness for 5 Hours, then 15% Brightness for 6 Hours To choose your desired mode, press the "ON/OFF" button once, when in Mode 1 a RED indicator light will flash, press again for Mode 2 and a GREEN indicator light will flash. IMPORTANT NOTES Please ensure you place your Solar Panel in a location where it can achieve a minimum of 6HRS DIRECT SUNLIGHT Be aware that on overcast/cloudy days, the solar panel will still charge. However, not as efficiently as a sunny day, so the battery may not reach full capacity. Therefore, your light may turn off earlier than specified. It's best not to install these lights underneath a street light, porch light etc. because this may stop the automatic day/night operation triggering and result in your lights not turning on. TROUBLE SHOOTING Phenomenon Cause Inspection Method Solution Light won't turn on The light only stays on for a short amount of time Switch hasn't been turned on Battery has run flat Low Battery Battery Failure Determine what position the switch is in Turn the switch on Period of rainy or cloudy weather or installation site doesn't provide enough direct sunlight 1. Bad installation site for the solar panel 2. Dust or leaves are covering the panel 3. Long period of overcast weather 1. Access the light and & replace battery 2. Battery has matured Charge the light in direct sunlight for 1-2 days then check again 1. Charge the battery in direct sunlight for 1-2 days with the switch off, then check again 2. Clean the solar panel Contact SLD Customer Service to buy new batteries Torx Screws Surface Mounted Base "ON/OFF" Button Customer Service Number: 1300 135 911 www.solarlightingdirect.com.au