AJAX FH.54.J-000-EU Fire Hub Jeweller Declaration of Conformity

II. Regulatory Technical Specifications

1. If the construction product is covered by a national standard for the purposes of the Law of Ukraine "On placing construction products on the market":

Designation, name, date of adoption of national standards:
- DSTU EN 54-2:2003 with amendment No. 1:2012 and corrigendum No. 1:2019 "Fire alarm systems. Part 2. Fire detection and fire alarm systems (EN 54-2:1997/AC:1999/A1:2006, IDT)"
- DSTU EN 54-4:2003 with amendment No. 2:2012, DSTU EN 54-4:2019 with amendment No. 1:2019 and corrigendum No. 1:2019 "Fire alarm systems. Part 4. Power supply equipment (EN 54-4:1997/AC:1999/A1:2002/A2:2006, IDT)"
- DSTU EN 54-21:2009 "Fire alarm systems. Part 21. Fire alarm devices and fault warning devices (EN 54-21:2006, IDT)"
- DSTU EN 54-25:2010 with amendment No. 1:2019 "Fire alarm systems and devices. Part 25. Components of the system using radio links (EN 54-25:2008/AC:2012, IDT)"
Information on the notified body (bodies) for conformity assessment (if applicable):
- Name: STATE CERTIFICATION CENTER OF THE STATE EMERGENCY SERVICE OF UKRAINE
- EDRPOU Code: 14319662
- Notified Body Identification Number: UA.TR.056.

2. If a technical acceptability opinion has been issued for the construction product: Not applicable/Not provided.

III. Declared construction product performance indicators related to its essential performance characteristics

Based on DSTU EN 54-2:2003 with amendment No. 1:2012 and corrigendum No. 1:2019

List of essential performance characteristics	Performance indicators of essential performance characteristics	Designation and title of the regulatory technical specification
General requirements	4	Complies
Basic indication requirements	5	Complies
Standby mode	6	Complies
Fire alarm mode	7	Complies
Fault warning mode (see Annex F)	8	Complies
Shutdown mode	9	Complies
Test mode (optional function with requirements)	10	Not applicable to this product
Standardized input/output interface (optional function with requirements - see Annex G)	11	Not applicable to this product
Construction requirements	12	Complies
Additional design requirements for software-controlled fire alarm control panels	13	Complies
Marking	14	Complies
Cold (under operating conditions)	15.4	Complies
Damp heat, steady state (under operating conditions)	15.5	Complies
Impact (under operating conditions)	15.6	Complies
Vibration, sinusoidal (under operating conditions)	15.7	Complies
Electromagnetic compatibility (EMC) (under operating conditions)	15.8	Complies
Mains voltage variations (under operating conditions)	15.13	Complies
Damp heat, steady state (long-term exposure)	15.14	Complies
Vibration, sinusoidal (long-term exposure)	15.15	Complies

Based on DSTU EN 54-4:2003 with amendment No. 2:2012, DSTU EN 54-4:2019 with amendment No. 1:2019 and corrigendum No. 1:2019

List of essential performance characteristics	Performance indicators of essential performance characteristics	Designation and title of the regulatory technical specification
General requirements	4	Complies
Functions	5	Complies
Materials, construction and manufacturing	6	Complies
Documentation	7	Complies
Marking	8	Complies
Cold (under operating conditions)	9.5	Complies
Damp heat, steady state (under operating conditions)	9.6	Complies
Impact (under operating conditions)	9.7	Complies
Vibration, sinusoidal (under operating conditions)	9.8	Complies
Electromagnetic compatibility (EMC) (under operating conditions)	9.9	Complies
Damp heat, steady state (long-term exposure)	9.14	Complies
Vibration, sinusoidal (long-term exposure)	9.15	Complies

Based on DSTU EN 54-21:2009 (type 1, 2)

List of essential performance characteristics	Performance indicators of essential performance characteristics	Designation and title of the regulatory technical specification
General provisions	4	Complies
Functional requirements	5	Complies
Construction requirements	7	Complies
Marking	8	Complies
Power supply	9	Complies
Cold (under operating conditions)	10.4	Complies
Damp heat, steady state (under operating conditions)	10.5	Complies
Impact (under operating conditions)	10.6	Complies
Vibration, sinusoidal (under operating conditions)	10.7	Complies
Electromagnetic compatibility (EMC) (under operating conditions)	10.8	Complies
Mains voltage variations (under operating conditions)	10.9	Complies
Damp heat, steady state (long-term exposure)	10.10	Complies
Vibration, sinusoidal (long-term exposure)	10.11	Complies

Based on DSTU EN 54-25:2010 with amendment No. 1:2019

List of essential performance characteristics	Performance indicators of essential performance characteristics	Designation and title of the regulatory technical specification
General provisions	4.1	Complies
Protection against signal fading due to location	4.2.1	Complies
Alarm signal retention	4.2.2	Complies
Identification of system components using radio communication	4.2.3	Complies
Receiver parameters	4.2.4	Complies
Interference immunity	4.2.5	Complies
Connection loss	4.2.6	Complies
Antenna	4.2.7	Complies
General provisions	5.2	Complies
Power supply equipment	5.3	Complies
Environmental influence tests	5.4	Complies
Documentation	6	Complies
Marking	7	Complies
Protection against signal fading due to location	8.2.2	Complies
Alarm signal retention tests	8.2.3	Complies
Identification of system components using radio communication	8.2.4	Complies
Receiver parameter verification	8.2.5	Complies
Mutual interference between systems from the same manufacturer	8.2.6	Complies
Compatibility with other frequency band users	8.2.7	Complies
Line fault detection	8.2.8	Complies
Antenna tests	8.2.9	Complies
General provisions	8.3.1	Complies
Program for system component testing	8.3.2	Complies
Testing of autonomous power source operating life	8.3.3	Not applicable to this product
Alarm signal warning of low power supply voltage	8.3.4	Not applicable to this product
Polarity reversal tests	8.3.5	Complies
Repeatability tests	8.3.6	Complies
Reproducibility tests	8.3.7	Complies
Dry heat (under operating conditions)	8.3.9	Not applicable to this product
Dry heat (long-term exposure)	8.3.10	Not applicable to this product
Cold (under operating conditions)	8.3.11	Not applicable to this product
Damp heat, cyclic (under operating conditions)	8.3.12	Not applicable to this product
Damp heat, steady state (under operating conditions)	8.3.13	Complies
Damp heat, steady state (long-term exposure)	8.3.14	Complies
Corrosive atmosphere (SO2) (long-term exposure)	8.3.15	Not applicable to this product
Bump (under operating conditions)	8.3.16	Not applicable to this product
Shock (under operating conditions)	8.3.17	Complies
Vibration, sinusoidal (under operating conditions)	8.3.18	Complies
Vibration, sinusoidal (long-term exposure)	8.3.19	Complies
Electromagnetic compatibility (EMC), protection against interference (under operating conditions)	8.3.20	Complies

IV. Other Information

1. Information on relevant and/or special technical documentation used: Not specified.

2. Information on the attestation of construction product performance:

Essential performance characteristics identified in points 1 and 2 of Section I correspond to the declared performance indicators of the construction product related to its essential performance characteristics.
Declaration is drawn up in accordance with the Law of Ukraine "On placing construction products on the market".
The declaration confirms that the manufacturer, specified in point 4 of Section I, takes responsibility for the compliance of the construction product with the declared indicators.

3. Information about the person signing the declaration on behalf of the manufacturer:

Initials (first initial of given name) and surname: S. V. Ivchun
Position (if any): Representative based on power of attorney dated 01.11.2023
Date of declaration: September 1, 2025.

[Company Stamp]

	AJAX EN54 Fire Hub Jeweller FH.54.J-000-EU: Declaration of Performance Official Declaration of Performance for the AJAX EN54 Fire Hub Jeweller (model FH.54.J-000-EU) by AS MANUFACTURING LLC, confirming compliance with harmonized European standards for fire detection and alarm systems.
	AJAX Fire Hub Jeweller Declaration of Conformity - Compliance with EN Standards Official Declaration of Conformity for the AJAX Fire Hub Jeweller (Model FH.54.J-000-EU), confirming compliance with relevant European (EN, IEC, ETSI) and Ukrainian technical regulations for radio equipment and safety.
	AJAX FH.54.J-000-EU Certificate of Constancy of Performance Certificate of Constancy of Performance for AJAX FH.54.J-000-EU fire detection and alarm system components, confirming compliance with relevant EN standards for fire safety equipment, issued by Dedal Attestation & Certification.
	AJAX Funk-Brandwarnanlagen: Sichere Lösung für Hotels und Pensionen Erfahren Sie mehr über die EN54-zertifizierten AJAX Funk-Brandwarnanlagen, ideal für Hotels und Pensionen. Entdecken Sie die Komponenten wie Brandwarnzentrale, Melder und Signalgeber für höchsten Brandschutz.
	AJAX Funk-Brandwarnanlagen für Schulgebäude: Sicherheit und Zuverlässigkeit Umfassender Überblick über AJAX Funk-Brandwarnanlagen für Schulgebäude, die Sicherheit und Zuverlässigkeit mit EN54-zertifizierten Komponenten, fortschrittlicher Detektion und benutzerfreundlicher App-Integration gewährleisten.
	AJAX EN54 FireProtect (Smoke/Sounder) Jeweller - Declaration of Performance Declaration of Performance for the AJAX EN54 FireProtect (Smoke/Sounder) Jeweller (model FP.54SA.J-000-EU) by AS MANUFACTURING LLC, detailing its compliance with harmonized standards for fire detection and alarm systems.
	AJAX EN54 FireProtect (Heat) Jeweller Declaration of Performance Declaration of Performance for the AJAX EN54 FireProtect (Heat) Jeweller model FP.54H.J-000-EU, detailing its compliance with harmonized technical specifications for fire detection and alarm systems.
	EN54 FireProtect (Heat) Jeweller User Manual User manual for the Ajax EN54 FireProtect (Heat) Jeweller, a wireless addressable point heat detector compliant with EN 54-5 standards. Covers installation, operation, settings, and troubleshooting.

Declaration of Construction Product Performance

I. General Information