Philips Customer Service Support - Home | Philips
Instruction Manual for PHILIPS models including: AZB500 CD Sound Machine, AZB500, CD Sound Machine
File Info : application/pdf, 2 Pages, 4.19MB
DocumentDocumentCD Soundmachine AZB500 lnformation Before using your product,read all accompanying safety information. 6X1.5V R14/UM2/C CELL To play with the device, you can use either alkaline battery (R14) or AC power. AUDIO-IN/CD RADIO OFF For first time use Use DAB menus 1 In DAB mode,press MENU to access the DAB menus. 2 Press to toggle through the menus. 3 Press OK to enter the menu. VOLUME DBB 2021 © MMD Hong Kong Holding Limited. All rights reserved. Specifications are subject to change without notice. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license. This product has been manufactured by and is sold under the responsibility of MMD Hong Kong Holding Limited or one of its affiliates, and MMD Hong Kong Holding Limited is the warrantor in relation to this product. AZB500_79_Short User Manual_V6.0 AUDIO-IN/CD RADIO OFF AUDIO IN Tune to a radio station AUDIO-IN/CD RADIO OFF MODE AUDIO-IN/CD RADIO OFF PROG MODE Press to skip to the previous/next track. Press and hold to search within play,then release to resume play. Start of pause play. Stop play or erase a program. Program the sequence of tacks. Select a play mode. PROG Program FM radio stations automatically Press and hold PROG for 2 seconds to activate automatic programming. All available radio stations are stored automatically,then the first stored radio station is broadcast. PROG PROG PROG Program tracks 1 Press to stop playback. 2 Press PROG to activate the program mode. 3 Press to select a track,then press PROG to confirm. 4 Repeat steps 3 to program more tracks. 5 Press to play the programmed tracks. · To erase the program,press twice. Note: · In CD mode,the CD sound machine switches to standby mode automatically if there is no audio signal detected for over 15 minutes. · Press to wake up the CD sound machine from standby mode. Specifications Amplifier Rated Output Power Frequency Response Signal to Noise Ratio Audio-in Input Disc Laser Type Disc Diameter Support Disc Frequency Response S/N Ratio Tuner Tuning Range Sensitivity: Mono,26dB S/N Ratio Stereo,46dB S/N Ratio 2 x 1W RMS 125 - 16000 Hz,-3dB >55 dBA 650 mV RMS Semiconductor 12cm/8cm CD-DA,CD-R,CD-RW 125-16000 Hz,-3dB >55 dBA FM:87.5 - 108 MHz DAB:174.928 -239.200 MHz <22 dBf <43 dBf Search Selectivity Total Harmonic Distortion Signal to Noise Ratio 50KHZ(FM) <3% >50 dBA General Power supply -AC Power -Battery Operation Power Consumption Standby Power Consumption Dimensions -Main Unit(W x H x D) Weight (Main Unit) 220-240V_,50/60 Hz; DC 9V,6x1.5V type; R14/UM2/C CELL 10W <0.5W 300 x 134 x 240mm 1.4kg 1 Important Safety Read these instructions. Follow all instructions. Do not block any ventilation openings. Install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators,heat registers,stoves,or other apparatus(including amplifiers)that produce heat. Protect the power cord from being walked on or pinched,particularly at plugs,convenience receptacles,and the point where they exit from the unit. Only use attachments/accessories specified by the manufacturer. Unplug this unit during lightning storms or when unused for long periods of time. Recording is permissible insofar as copyright or other rights of third parties are not infringed upon. Refer all servicing to qualified service personnel.Servicing is required when the unit has been damaged in any way,such as power-supply cord or plug is damaged,liquid has been spilled or objects have fallen into the apparatus,the unit has been exposed to rain or moisture,does not operate normally,or has been dropped. Battery usage CAUTION - To prevent battery leakage which may result in bodily injury,property damage,or damage to the unit: · Install all batteries correctly,+ and - as marked on the unit. · Do not mix batteries(old and new or carbon and alkaline,etc.). · Remove batteries when the unit is not used for a long time. Batteries(battery pack or batteries installed)shall not be exposed to excessive heat such as sunshine,fire or the like. CAUTION:Danger of explosion if battery is incorrectly replaced.Replace only with the same or equivalent type. The unit shall not be exposed to dripping or splashing. Do not place any sources of danger on the unit(e.g.liquid filed objects,lighted candles). Where the MAINS plug or an appliance coupler is used as the disconnect device,the disconnect device shall remain readily operable. Warning Never remove the casing of this apparatus. Never place this apparatus on other electrical equipment. Never look into the laser beam inside this apparatus. Caution Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Notice Any changes or modifications made to this device that are not expressly approved by MMD Hong Kong Holding Limited may void the user's authority to operate the product.Hereby, TP Vision Europe B.V. declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. You can find the Declaration of Conformity on www.philips.com/support. Disposal of your old product Your product is designed and manufactured with high quality materials and components,which can be recycled and reused. This symbol on a product means that the product is covered by European Directive 20212/19/EU.Inform yourself about the local separate collection system for electrical and electronic products. Follow local rules and never dispose of the product with normal household waste. Correct disposal of old products helps prevent negative consequences for the environment and human health. Environmental information All unnecessary packaging has been omitted. We have tried to nake the packaging easy to separate into three materials:cardboard(box) paper pulp(buffer)and polyethylene(bags,protective foam sheet.) Your system consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials,exhausted batteries and old equipment. This apparatus includes these labels: Class || equipment symbol This symbol indicates that the apparatus has a double insulation system. The making of unauthorized copies of copy-protected material,including computer programs,files,broadcasts Be responsible Respect copyrights and sound recordings,files,broadcasts and sound recordings,may be an infringement of copyrights and constitute a criminal offence. This equipment should not be used for such purposes. Note The type plate is located on the bottom of the apparatus.