User Guide for Kessil models including: 05262022, DMX Track, LED Light Panel, DMX Track LED Light Panel
DMX Track | Kessil LED
Track End Feed Wiring Guide Track End Feed Wiring Guide Wire Power to End Feed VIDEO LINKS Wire DMX to Wire DMX to Wire DMX to End Feed via XLR5 End Feed via RJ45 End Feed via TRRS Link to Video Link to Video Link to Video Link to Video STEP-BY-STEP INSTRUCTIONS Please refer to the listed QR Code/Links for detailed step-by-step instructions for the wiring cable per installation requirements. Contact design@kessil.com for more information. READ AND SAVE ALL INSTRUCTIONS · Disconnect electrical power before adding to or changing the configuration of the track. · Do not install this track in damp or wet locations (IP20 , 45°C max). · Do not install any part of a track system less 5 ft. above the floor. · Check with a qualified electrician prior to any installation. · Do not attempt to energize anything other than lighting track fixtures on the track. · In order to reduce the risk of fire and electrical shock, do not attempt to connect power tools, extension cords, appliances and the like to the track. · Do not slide light fixtures along track when relocating. Always remove fixture/adapter from track. · Before reinstalling in new location, make sure to properly secured adapter back in track. 1689 Regatta Blvd. Richmond, CA 94804 | Kessil@Kessil.com | (510) 620-5250 05262022A Wire Power to End Feed Each End Feed component has two (2) sets of 20A-max conductors for two (2) individual power circuits. Line drawing of power splicing on End Feed Legend A 233 Series, 2 Circuit 120V Track B Securing screw for end feed component C DMX/Data conductor entry D D Power conductor entry for Circuit 1 and Circuit 2 A C B Link to Video Track End Feed Wiring Guide End feed Component with pin-outs DATA (DATA WIRE) GROUND (GROUND WIRE) N1 (NEUTRAL WIRE) L1 (HOT WIRE) GIRCUIT 2 GIRCUIT 1 EACH CIRCUIT CAN HANDLE A MAXIMUM CURRENT OF 20 AMPS 1689 Regatta Blvd. Richmond, CA 94804 | Kessil@Kessil.com | (510) 620-5250 Wire DMX to End Feed DMX signal requires 2 signal carriers and the polarity of the DMX conductors are labelled on the sticker located on the end feed component. DMX Polarity Label Sticker DMX Conductors wired to End Feed 1689 Regatta Blvd. Richmond, CA 94804 | Kessil@Kessil.com | (510) 620-5250 Track End Feed Wiring Guide Wire DMX to End Feed Continued Standard DMX Cabling and Polarity XLR5 Connector RJ45 TRRS Description DMX lighting standard Architectural, corporate, and fixed installations Fiilex DMX Controller, P360 Pro and P360 Pro Plus. 1 Connector Pin-out 2 3 Ground 1 Data - 2 Data + 3 #1 #2 #7&8 Tip Ring 1 Ring 2 Sleeve 7 , Tip 2 Ring1 (closest to tip) 1 Sleeve Video Guide Link to Video Link to Video Link to Video Track End Feed Wiring Guide Signal 1689 Regatta Blvd. Richmond, CA 94804 | Kessil@Kessil.com | (510) 620-5250Adobe PDF library 10.01 Adobe Illustrator CS6 (Windows)