ELKO EP - Global relay manufacturer • ELKO EP
Instruction Manual for ELKOep models including: GPSR-1 A4 1jaz, GPSR-1 GPS Receiver, GPSR-1, GPS Receiver, Receiver
1 / 1 GPSR-1 02-1/2022 Rev.: 0 GPSR-1 Made in Czech Republic LED LED A2 16 15 18 A1 G B1 B2 Un GPSR-1-max. 100 m 1 3 2 1 2 3 4 5 6 4 ELKO EP, s.r.o.
File Info : application/pdf, 2 Pages, 124.98KB
DocumentDocumentELKO EP, s.r.o. Palackého 493 769 01 Holesov, Vsetuly Czech Republic Tel.: +420 573 514 211 e-mail: elko@elkoep.com www.elkoep.com Made in Czech Republic 02-1/2022 Rev.: 0 Characteristics · GPS module, designed for synchronization of switching clock SHT-6. · Two-wire connection using screwless terminals - no matter the polarity! · Connection cable length up to 100m. · Optical indication of module functional states. · It broadcasts time information in DCF 77 format. · Setting the time zone of the DIP switch (UTC-12 to UTC+14). · Choice of one of 40 time zones · The receiver is only compatible with the new SHT-6G version (EAN: · 8595188182751) and firmware 2.37 or higher Description 3 1 LED 4 max. 100 m 2 LED 123 456 Connection with SHT-6 1. Connection terminals with SHT-6 2. Indication of operating states 3. Sync indication 4. DIP switches to set the time zone GPSR-1 Receiver GPS Installation · It must be mounted so that there are no obstacles between the GPS receiver and the direction of reception (trees, roofs of buildings, etc.) · There must not be any transformers, contactor relays, fluorescent lamps, etc., placed in the immediate vicinity of the GPS receiver (about 1m) · Do not install GPS receiver near metal objects, el. cables, etc. LED indication EN Reception direction Reception direction Reception direction A1 G B1 B2 Un GPSR-1 red LED (under cover) Failure of internal circuits Searching for GPS signal Synchronization time. Information GPS signal OK - sending time information green LED - (1s) A2 16 15 18 If a shielded cable is used, connect the shield to terminal G. Technical parameters GPSR-1 Connected: Max. voltage on conductors: Other information Working temperature: Storage temperature: Covers: Terminal plate: Cross-section of connecting conductors: About the connection cable: Dimension: Weight: Reception area: two-wire, it does not depend on polarity DC 10 V -20.. +55 °C -30.. +70 °C IP65 screwless clamps drat: 0.2 - 0.75 mm2 / cable + core: 0.25 - 0.34 mm2 max. 6.5 mm 98 x 62 x 34 mm 96 g whole world Function GPSR-1 is designed to receive and decode the signal GPS. The correct operation is indicated by the red LED flashing at interval 1s. Warning Installation and connection should only be carried out by a qualified installer or electrician, who is thoroughly familiar with these instructions and functions of device. Before starting the installation, please make sure that the device is de-energized and the main switch is in the off position. For installation and setting use screw-driver cca 2 mm. The device is fully-electronic - installation should be carried out according to this fact. Non-problematic function depends also on the way of transportation, storing and handling. In case of any signs of destruction, deformation, non-function or missing part, don´t install and claim at your seller it is possible to dismount the device after its lifetime, recycle, or store in protective dump. 1 / 1 Overview of time zones Set up time zones Function 0 TEST LED + DIP switches 1 UTC 2 UTC+1 3 UTC+2 4 UTC+3 5 UTC+3:30 6 UTC+4 7 UTC+4:30 8 UTC+5 9 UTC+5:30 10 UTC+5:45 11 UTC+6 12 UTC+6:30 13 UTC+7 14 UTC+8 15 UTC+8:45 16 UTC+9 17 UTC+9:30 18 UTC+10 19 UTC+10:30 20 UTC+11 21 UTC+11:30 22 UTC+12 23 UTC+12:45 24 UTC+13 25 UTC+14 26 UTC-12 27 UTC-11 28 UTC-10 29 UTC-9:30 30 UTC-9 31 UTC-8 32 UTC-7 33 UTC-6 34 UTC-5 35 UTC-4:30 36 UTC-4 37 UTC-3:30 38 UTC-3 39 UTC-2 40 UTC-1 41...61 not used 62 TEST communication 63 TEST LED + DIP switches DIP-1 OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF ON ON ON ON ON ON ON ON ON ON ON DIP-2 OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON OFF OFF OFF OFF OFF OFF OFF OFF OFF ON ON DIP-3 OFF OFF OFF OFF OFF OFF OFF OFF ON ON ON ON ON ON ON ON OFF OFF OFF OFF OFF OFF OFF OFF ON ON ON ON ON ON ON ON OFF OFF OFF OFF OFF OFF OFF OFF ON ON ON DIP-4 OFF OFF OFF OFF ON ON ON ON OFF OFF OFF OFF ON ON ON ON OFF OFF OFF OFF ON ON ON ON OFF OFF OFF OFF ON ON ON ON OFF OFF OFF OFF ON ON ON ON OFF ON ON DIP-5 OFF OFF ON ON OFF OFF ON ON OFF OFF ON ON OFF OFF ON ON OFF OFF ON ON OFF OFF ON ON OFF OFF ON ON OFF OFF ON ON OFF OFF ON ON OFF OFF ON ON OFF ON ON DIP-6 OFF ON OFF ON OFF ON OFF ON OFF ON OFF ON OFF ON OFF ON OFF ON OFF ON OFF ON OFF ON OFF ON OFF ON OFF ON OFF ON OFF ON OFF ON OFF ON OFF ON OFF OFF ON