LUNOS Universal Control with 5/W2U Switch: Mounting Humidity Sensor/LED

5/UNI-FT & RF - Mounting Humidity Sensor/LED on Switch 5/W2U

Step 1: Assign terminals correctly

This step details the correct terminal assignment for connecting the 5/UNI-FT module to the 5/W2U switch. The accompanying diagram illustrates the following:

• Switch 5/W2U Backside: Shows the rear of the switch with its terminal connections.
• Switch 5/W2U Front side: Displays the front of the switch, including its operational buttons.
• Module Components:
  • Internal push button
  • Coding switch
  • Connection cable leading to the switch
  • Humidity-temperature sensor
  • LED indicator
• Wire Connections: The module connects to the switch using violet, grey, and orange wires, each corresponding to specific terminals.
• Connection Cable Instructions: Textual warnings state: "Do not shorten!" and "Do not extend!".

Step 2: Pierce the sticker on the back

This step guides the user on preparing the rear of the 5/W2U switch. The diagram shows:

• The back surface of the switch, featuring a sticker that includes a "CE" certification mark.
• A red arrow indicating the precise location to pierce the sticker, with the instruction "Pierce through the centre here".

Step 3: Insert humidity sensor/LED

This step describes the physical insertion of the humidity sensor and LED module into the switch. The diagram illustrates:

• The humidity sensor/LED module being carefully inserted into the 5/W2U switch.
• An instruction text stating: "Insert the sensor board completely".

Step 4: Install control unit and switch in flush-mounted box - done

This final step conceptually depicts the completed installation, showing the control unit and the 5/W2U switch properly housed within a standard flush-mounted electrical box.

Note: The 5/W2U switch is identified as being manufactured by Kopp, from their Paris series, in the arctic white color variant.