Instruction Manual for rutec models including: ANLEITUNG1, ALU57345UWWD, ALU57345UWWD Downlight Dimmable Set-Single Plug and Play, Downlight Dimmable Set-Single Plug and Play

Layout 1

Manuela

Instruction 1

TALU LED-Einbaustrahler 1er Set dimmbar Plug&play schwenk.,rund,350mA,8W,IP20,3000K,CRI90 - Weiß - rutec Lightdesign

ANLEITUNG1 ALU57341WWD
TALU LED-Einbaustrahler 1er Set dimmbar Plug & Play
Stromschlaggefahr! Beauftragen Sie mit der Installation eine Elektrofachkraft. Für Strahler, die nicht gemäß den europäischen Sicherheitsrichtlinien installiert wurden, entfällt jeder Haftungsanspruch.
Brandgefahr! Strahler nicht mit wärmedämmenden Stoffen abdecken.
Achtung! Für alle Anschlüsse sekundärseitig des Konverters ist ausschließlich die mitgelieferte Niedervoltleitung zu verwenden.
Der Strahler ist zur Montage auf normal entflammbaren Oberflächen geeignet, z.B. auf Holz und Werkstoffen auf Holzbasis mit mehr als 2 mm Stärke. Strahler nur nach unten strahlend montieren.
Einbau mit Haltefedern: Die Haltefedern müssen nach der Installation in horizontaler Position liegen, nicht vertikal (Abb. 1)

Montage
Stromschlaggefahr! Vor der Installation Spannung abschalten. Sicherstellen, dass die Spannung nicht versehentlich wieder eingeschaltet werden kann.
1. Loch am Montageort sägen. Der Durchmesser beträgt 68 mm.
2. Elektrischer Anschluss: TALU Plug & Play Einbaustrahler, mithilfe des mitgelieferten Steckverbinders, an die sekundärseitige Leitung des Konverters, mit passendem Gegenstück des Steckverbinders, anschließen. An die Primärseite des Konverters die vorhandene 230V AC Netzspannung anschließen (Abb. 2).
230V AC
Abb. 2
3. Federn des Einbaustrahlers zusammendrücken und diesen in das ausgesägte Loch einsetzen (Abb.3).

low flicker N AC INPUT L

ta=50°C tc=85°C DC -OUT+PUT

LED Konverter Konstantstrom dimmbar Phasenabschnitt Art.-Nr.: 85445PNP-V2 Input: 230V AC; 50/60Hz
Output: 350mA P-out: 6.2-8W
SELV

falsch

Abb. 1

richtig

Technische Daten: siehe Aufkleber auf Einbaustrahler.

Inbetriebnahme: Betreiben Sie den Schutzklasse III Einbaustrahler TALU Plug & Play ausschließlich an dem dafür vorgesehenen Konstantstrom-Konverter (im Lieferumfang enthalten).
CE-konform mit den zutreffenden europäischen Richtlinien.

4. Spannung einschalten.

Abb. 3

Carl-Zeiss-Str. 15 28857 Syke

TALUPNP_BA_12/2020

G TALU LED-downlight dimmable
set-single plug & play
Danger of electrocution! Be sure to have a professional electrician complete installation. There is no warranty coverage for any lamps installed without observing European safety directives.
Fire hazard! Do not cover lamps with heat insulating materials.
Caution! Only the supplied low voltage cable must be used for all connections on the secondary side of the converter.
The Downlight is suitable for mounting on normally flammable surfaces such as wood and particle board materials which are more than 2 mm thick. Only install downlights so that they shine downwards.
Installation of mounting springs: Make sure that the springs are in the right position (fig. 1).

Assembly
Stromschlaggefahr! Switch off voltage prior to installation. Ensure that voltage cannot be accidentally switched on again.
1. Saw a hole at the installation location. The diameter is 68 mm.
2. Electrical connection: Connect the TALU Plug & Play recessed downlight to the secondary side line of the converter using the connector supplied with the matching counterpart of the connector. Connect the existing 230V AC mains voltage to the primary side of the converter (fig. 2).
230V AC
fig. 2
3. Press the springs together and place the downlight in the sawn out hole (fig. 3).

low flicker N AC INPUT L

ta=50°C tc=85°C DC -OUT+PUT

LED Konverter Konstantstrom dimmbar Phasenabschnitt Art.-Nr.: 85445PNP-V2 Input: 230V AC; 50/60Hz
Output: 350mA P-out: 6.2-8W
SELV

right

fig. 1

Technical data: See label on downlight.

wrong

Installation: Only operate the protection class III recessed downlight TALU Plug & Play with the constant Current converter provided for it (including in delivery).
CE compliant with the applicable European directives.

4. Switch on the mains voltage.

fig. 3

Carl-Zeiss-Str. 15 28857 Syke

TALUPNP_BA_12/2020


QuarkXPress(R) 14.35