AXTON LED Lighting Solutions, Infrared, White & Hybrid, USA Mfr.
User Guide for AXTON models including: AT-25Y, AT-56Y, 530 -Range Essential Infrared Illuminator with Day Night Sensor
AXTON Illuminators have been designed and tested to run 24/7 continuously both indoors and outdoors. Illuminator will trigger ON/OFF using the built in ambient light sensor
AXTON AT-56Y-S-56YS1810 Helios Series IR Illuminator with Day/Night Sensor, 9-28V DC Input, 10°
AXTON AT-56YW-S-56YWS116030 Helios Series White Light IR Illuminator with Day/Night Sensor, 9-28V DC Input, 60°x30°
File Info : application/pdf, 1 Pages, 379.12KB
DocumentDocumentQuick Setup Guide HELIOS AT-25Y | AT-56Y WIRING OPTION 1 Constant ON AXTON Illuminators have been designed and tested to run 24/7 continuously both indoors and outdoors. TO / FROM ILLUMINATOR Apply Power Jumper WHITE Power Input BLACK BROWN IN GREEN Day/ Night YELLOW OUT BLUE Digital GND OPTION 2 Automatic Illuminator will trigger ON/OFF using the built in ambient light sensor which has been pre-set to a threshold of 5-15 lux. ON will trigger immediately while OFF will trigger after a 12-18 second delay. TO / FROM ILLUMINATOR Apply Power Jumpers WHITE Power Input BLACK BROWN IN GREEN Day/ Night YELLOW OUT BLUE Digital GND OPTION 3 External Controller (e.g. Camera) You will need to log into the camera via the computer and program the I/O ports to trigger when IR illumination is desired. Make all electrical connections BEFORE applying power. Voltage Input 12VDC Applying voltage other than the required range may cause permanent damage and VOID WARRANTY. WARNING! Infrared light is not visible. Do not view directly with optical instruments (magnifiers) or stare directly into the illuminator at close distance. Do not attempt to open or modify the light as this will void the warranty. If you need a modification, electric or physical, contact us directly. We will let you know if it can be done. All changes MUST be made at our factory. TO/ FROM CAMERA TO / FROM ILLUMINATOR Apply Power Must Be Connected to Cameras Digital Ground WHITE Power Input BLACK BROWN IN GREEN Day/ Night YELLOW OUT BLUE Digital GND To switch illuminator ON, your camera output port(s) have to be ACTIVE and set to LOW (GND-ground). You may associate this action with various events (IR cut filter, motion detection, etc.) available on your camera or external device. QUESTIONS ? (801) 519-0500 or support@axtontech.com axtontech.com 801 Robinson Drive, Suite 500, North Salt Lake, UT 84054 < % q801/519-0500 801/519-0501 sales@axtontech.com MadeintheUSA LifetimeWarranty