TKH Security - Home – TKH Security
User Guide for TKH SECURITY models including: PD950DC 5MP Network PTZ Dome with 40x Zoom, PD950DC, 5MP Network PTZ Dome with 40x Zoom, Network PTZ Dome with 40x Zoom, PTZ Dome with 40x Zoom, Dome with 40x Zoom, 40x Zoom, Zoom
File Info : application/pdf, 2 Pages, 756.60KB
DocumentDocumentPD950DC 5MP Network PTZ Dome with 40x zoom Quick Start Guide Find additional manuals, the datasheet, the EU Declaration of Conformity, and the latest firmware for this product at: https://tkhsecurity.com/ Unpack M5 security screw Quick Start Guide Security Torx with rubber Camera Unit 3-pin power terminal block (AC24V use) Grommet holder 1.5" threaded tube adapter 14-pin Alarm/Audio I/O terminal block Grommet RJ45 insertion tool Note 1: Subject to modification. Actual product and accessories may differ in appearance. Connector Definition No. Connector Definition 1 Console Connector Reserved for manufacturer use RJ-45 Port 2 (Contact TKH Security for a compatible PoE For network and PoE+ connections injector.) 3 Power (AC24V) AC24V power connection 4 BNC For analog video output 5 Audio/Alarm I/O & RS-485 Audio/Alarm I/O & RS-485 connection 6 Reset Button 7 SD Card Slot Press the button with a proper tool for at least 20 seconds to restore the system. Insert the SD card into the card slot to store videos and snapshots. Do not remove the SD card when the camera is powered on. Table 1 Connector definitions Installation Notices CAUTION: Installation shall be performed by qualified personnel only. Installation shall be in accordance with local procedures. If you use an external power supply, contact TKH Security to make sure that the power supply has the proper power specifications. Battery replacement shall not be applied in view of the risk of explosion. Make sure that the power supply complies with LPS requirements. When installing the camera, hook up the camera with the anti-drop chain of the pendant to the anti-drop ring (see figure 1). For more information, contact TKH Security. Figure 1 Position anti-drop ring and anti-drop chain Camera Cabling (1) Power Connector (AC 24V) Pin Definition 1 AC24V L 2 GND 3 AC24V N Table 3 Pin definition for AC24V power connection POWER RATING OF PD900 24VAC, 50-60Hz or 50/60Hz, 0.67A shall be supplied by power adapter. 55VDC, 0.39A shall be supplied by "PoE". Connectors Figure 2 Camera Connectors For the connector definitions, see table 1. NOTE: It is not recommended to continuously (24/7) record with the micro-SD card, as the camera may not support long-term continuous data read/write. Contact the manufacturer of the micro-SD card for information regarding the reliability and the life expectancy. Camera Cabling (2) PoE and Ethernet cable connection The green link LED is lit when there is a good network connection. The orange network LED flashes to indicate that there is network activity. NOTE: In some cases, an ethernet crossover cable may be needed when connecting the camera directly to the PC. Check the status of the link indicator and the activity indicator LEDs. If the LEDs are unlit, check the LAN connection. WARNING: For "PoE" input connection, use only with UL listed I.T.E. with "PoE" output. Description for the "PoE" is intended to be connected to not exposed (outside plant) networks or equivalent statement in installation instructions. © TKH Security B.V. 2022-2023 | PD950DC-QSG-EN | Version 3 (20231108) Audio/Alarm I/O and RS-485 connection See the diagram and the pin definitions below for the Audio/Alarm I/O and RS-485 connection. Accessing the camera Figure 3 Diagram of Audio/Alarm I/O and RS-485 connection pins Pin Definition Pin Definition 1 Audio Out 8 RS-485 D- 2 GND (Audio I/O) 9 Alarm In 4 3 Alarm Out A1 10 Alarm In 3 4 Alarm Out A2 11 Alarm In 2 5 Alarm Out B1 12 Alarm In 1 6 Alarm Out B2 13 GND (Alarm I/O and RS-485) 7 RS-485 D+ 14 Audio In Table 3 Pin definitions for Audio/Alarm I/O and RS-485 connection 1st time camera login IP = 10.x.y.z Network Switch IP = 10.1.1.1 Netmask: 255.0.0.0 DHCP Install browser-based viewer Set a strong password 2 1 Admin 1234 qwer1234 x6W@oM0a!9#F 3 x6W@oM0a!9#F 4 Auto detect with SDM2 1 SDM2-vx.xx-setup.zip 2 3 https://tkhsecurity.com/ Enter to the camera product page. Browser-based Viewer Figure 4 shows the main page of the IP camera user interface. Figure 4 Main page IP camera user interface Note 1: If the IE web interface is not showing video, you might need to open your firewall or set the OCX protocol to RTP-over-RTSP(TCP).