Grille Installation Instruction
For 2010-2013 Chevy Camaro LT / LS / RS / SS Short and With Logo Show
Part#: C76723/H
Rev. 131101
Parts List
| Item | Part Name | QTY | Description | Item | Part Name | QTY | Description |
|---|---|---|---|---|---|---|---|
| 1 | Mesh Grille | 1 | Stainless steel | 4 | small 'J' Hook | 4 | |
| 2 | Stud | 8 | 6-32×2" | 5 | Large 'J' Hook | 4 | |
| 3 | Lock nut | 8 | 6-32 | 6 | Washers | 8 |
Install Notes
Overlay: ✔️ | Replacement: ❌ | Drill: ❌ | Cut: ❌
Installation Steps
-
Identify the grille & hardware with parts list.
[Illustration: A black mesh grille with the Chevrolet bowtie emblem in the center.]
-
Pop hood, remove the black plastic cover (on top of OEM grille / front panel) from vehicle. This will allow access to the rear of the grille shell.
-
Secure the stud to the threaded holes on the rear of the grille.
[Illustration: Studs being attached to the rear of the grille. Text overlay: "8-6-32×2" Studs"]
-
Pop hood, remove the black plastic cover (on top of OEM grille / front panel) from vehicle. This will allow access to the rear of the grille shell. Note: If the space is too narrow to allow access to the rear of the grille shell, it is better to remove the OEM grille shell or front bumper from the vehicle.
-
Center the grille into the opening of the factory grille shell. Be sure the studs are through the OEM grille shell.
-
Fasten the billet grille insert on to the OEM grille with J-hooks, lock nuts on the back side of the OEM grille.
[Illustration: Close-up of J-hooks being attached to the grille and OEM mounting points. Text labels: "Small J-hooks" and "Large J- hooks"]
-
Make sure the grille is centered and tighten the fasteners.
-
Reinstall the black plastic cover which was removed in step 2.
-
Installation completed!!!
[Illustration: The installed grille on the front of a Chevrolet Camaro.]
The instruction here is for your reference only. You may need to bend the billet grille bars or tabs a little bit to adjust to fit. We strongly recommend the professional installer for best result. Please use masking tape and tape the OEM grille shell along the edge to protect your vehicle during installation. We are not responsible for any damage caused by the installation. Thank you for choosing our product!
