MOONRAKER
6 Metre 50 MHz Halo
SKU: 11-098
Tuning stub RG-58 @ 300mm long. Trim a couple of mm per cut; you should end around 265mm +/-.
Good starting point below, please try to keep each side equal.
Overall length approx 34" or 864mm.
Diagram showing the halo antenna structure:
- A central insulator connects the two halves of the halo.
- The overall length is approximately 34 inches or 864mm.
- Each side of the halo is equal in length.
- There are fixing brackets on each side.
- A drive arm is shown connected to the center.
- Dimensions indicate a 4" or 102mm spacing.
Connection instructions
A: This is the center bolt through the boom; connect the braid to this.
B: This is the center core of your chosen coax; this connects to the driven arm. Please make sure they're connected well and have no shorts. Then fit the cap.
We hope you have many QSO's and wish you all the best in the hunt for DX, 73 The Moonraker team.