Peerless-AV® | Peerless-AVPeerless-AV
Installation Guide for peerless-AV models including: DS-LEDTK, DS-LEDTK Series SEAMLESS Universal Trim Kit, SEAMLESS Universal Trim Kit, Universal Trim Kit, Trim Kit
DS-LEDTK-24VX8S - Peerless-av Universal Trim Kit For Dvled Video Walls 89mm To 150mm Deep | DirectDial.com Canada
DS-LEDTK-8VX5S - Peerless-av Universal Trim Kit For Dvled Video Walls 89mm To 150mm Deep | DirectDial.com Canada
DS-LEDTK-16VX5S - Peerless-av Universal Trim Kit For Dvled Video Walls 89mm To 150mm Deep | DirectDial.com Canada
File Info : application/pdf, 24 Pages, 3.78MB
DocumentDocumentDS-LEDTK Series *Actual configuration may vary ENG 1 2020-07-13 #:146-9054-4 (2021-10-27) WARNING ENG - This product is designed to be installed on plywood walls. Hardware is included for plywood installation. This product is designed to be installed on flat, unobstructed, vertical walls. Do not install on curved or angled walls. Before installing make sure the supporting surface will support the combined load of the equipment and hardware. Screws must be tightly secured. Do not overtighten screws or damage can occur and product may fail. Never exceed the Maximum Load Capacity. Always use an assistant or mechanical lifting equipment to safely lift and position equipment. This product is intended for indoor use only. Use of this product outdoors could lead to product failure or personal injury. Be careful not to pinch fingers when operating the mount. For support please call customer care at 1-800-865-2112. ENG Symbols ENG WARNING # ENG Skip to step. ENG Do not overtighten screws. 2 2020-07-13 #:146-9054-4 (2021-10-27) ENG Tools Needed for Assembly. ENG To properly tighten screws: Tighten until screw head makes contact, then tighten another 1/2 turn. Do not overtighten screws. 1 5/32" (4mm) 2 3 +1/2 3/8" (10mm) 4 1/4" (6mm) 3 2020-07-13 #:146-9054-4 (2021-10-27) ENG Parts (Before beginning, make sure you have all parts shown below). Parts List Description A solid cover B perforated cover C solid wall bracket D perforated wall bracket E corner cover assembly F nut bar G 1/4-20 x 0.375" socket screw H solid wall bracket spacer I outer cutting jig J inner cutting jig K wall plate shim L 1/4-20 x 25mm screw M #14-10 x 1.75 wood screw N M3 x 8mm phillips O 1/4-20 x 1/2" socket screw P vinyl sticker Q toggler R #8-18 X 3/4" self drilling screw S 4mm allen wrench Part # - 147-1876 147-T1881 10007616 147-T1880 147-T1882 147-T1883 147-1891 521-0710 521-1688 521-0711 520-1169 580-0535 590-1093 521-0714 560-9646 A solid cover D perforated wall bracket B perforated cover E corner cover C solid wall bracket F nut bar 4 2020-07-13 #:146-9054-4 (2021-10-27) G 1/4-20 x 0.375" socket screw H solid wall bracket spacer I outer cutting jig K wall plate shim J inner cutting jig M #14-10 x 1.75 wood screw O 1/4-20 x 1/2 R #8-18 X 3/4" N M3 x 8mm L 1/4-20 x 25mm P vinyl sticker S (1) 4mm allen wrench 5 Q toggler 2020-07-13 #:146-9054-4 (2021-10-27) 1 ENG Standard steps for solid or perforated trim kits. ENG Steps for Unilumin UpanelS sides with bump-outs. 1-1 4 6 2020-07-13 #:146-9054-4 (2021-10-27) 1-1 ENG Measure video wall dimensions. x" y" 1-2 ENG Mark cutting line on covers. Do not join covers until installing covers to the wall. Leave top and right cover edges uncut for proper alignment. x" A,B ENG Leave right edge uncut ENG Leave top edge uncut C,D ENG Uncut edges must form inside seam. y" A,B C,D 7 2020-07-13 #:146-9054-4 (2021-10-27) 2-1 ENG Optional: Clamp or fasten cutting fixture to side of cover being discarded. R (4) C,D I 2-2 R (4) 1/4" (6mm) A,B I ENG Discard C,D ENG Discard A,B 8 2020-07-13 #:146-9054-4 (2021-10-27) WARNING ENG - When installing Peerless wall mounts on a wood stud wall covered with plywood, verify that the wood studs are a minimum of 2" x 4" nominal size and plywood is a minimum Grade BC, 1/2" (13 mm) thick. Plywood may be covered by gypsum board (drywall) up to 5/8" thick. 3-1 ENG Align wallplates with edge of video wall. Using spacer to set final position. 1.375" (35mm) C,D H C,D ENG Spacer oriented so notch faces wall and covers. H H C,D 3-2 5/32" (4mm) ENG Drill mounting holes into supporting surface (1.75" (44mm) minimum depth required). 9 5/32" (4mm) 1.75" (44mm) 2020-07-13 #:146-9054-4 (2021-10-27) 3-3 ENG Install using wood screws provided. Use spacer to set final position of wall bracket. 3/8" (10mm) ENG Spacer oriented so notch faces wall and covers. H C,D M C,D ENG Maximum 80 in. · lb (9 N.M.). ENG Optional shim for leveling. C,D 8 10 M K 2020-07-13 #:146-9054-4 (2021-10-27) Alternate steps for Unilumin UpanelS sides with bump-outs 4 ENG To begin installing solid trim on Unilumin UpanelS edges with bumpouts, create guiding line around unit using spacer provided. ENG Use end without notch. H 11 2020-07-13 #:146-9054-4 (2021-10-27) 5-1 ENG Measure video wall dimensions x" ENG Measure to the pixel, not bump-outs. x" y" y" 5-2 ENG Mark cutting line on covers. Do not join covers until installing covers to the wall. Leave top and right cover edges uncut for proper alignment. x" A,B ENG Leave right edge uncut ENG Leave top edge uncut C,D ENG Uncut edges must form inside seam. y" A,B C,D 12 2020-07-13 #:146-9054-4 (2021-10-27) 6-1 ENG Optional: Clamp or fasten cutting fixture to side of cover being discarded. R (4) C,D I 6-2 R (4) 1/4" (6mm) A,B I ENG Discard C,D ENG Discard A,B 13 2020-07-13 #:146-9054-4 (2021-10-27) WARNING ENG - When installing Peerless wall mounts on a wood stud wall covered with plywood, verify that the wood studs are a minimum of 2" x 4" nominal size and plywood is a minimum Grade BC, 1/2" (13 mm) thick. Plywood may be covered by gypsum board (drywall) up to 5/8" thick. 7-1 ENG Align wall plates with display guiding lines. Mark mounting holes. C C 7-2 5/32" (4mm) ENG Drill mounting holes into supporting surface (1.75" (44mm) minimum depth required). 5/32" (4mm) 1.75" (44mm) 14 2020-07-13 #:146-9054-4 (2021-10-27) 7-3 ENG Install using wood screws provided. Do not fully tighten. 3/8" (10mm) C M ENG Maximum 80 in. · lb (9 N.M.). ENG Slide wall brackets in slot until they sit 1.25" from display guiding lines. Level and tighten wood screws. C 1.25" C C ENG Front View ENG Top View 1.25" 15 2020-07-13 #:146-9054-4 (2021-10-27) 8 ENG Follow steps for solid or perforated trim kits. C A C A 8-1 D B D B 9-1 16 2020-07-13 #:146-9054-4 (2021-10-27) 8-1 ENG Place wall plate cover over wall plate. Slide back until flush with front of video wall. S L A C Q 8-2 ENG Attach covers with nut bar inside cover. Displays not shown for clarity. A N (4) F A 17 2020-07-13 #:146-9054-4 (2021-10-27) 8-3 ENG Loosely attach all tooglers,then tighten. Displays not shown for clarity. C A L Q 8-4 ENG Use screwdriver to hold toggler in place while tightening toggler screws. S 8-5 P 10-1 18 2020-07-13 #:146-9054-4 (2021-10-27) 9-1 ENG Place wall plate cover over wall plate. Slide back until flush with front of video wall. S G A D 9-2 ENG Attach covers with nut bar inside cover. Displays not shown for clarity. A F N (4) A 19 2020-07-13 #:146-9054-4 (2021-10-27) 10-1 ENG Place corner cover against wall and mark cutting line. E 10-3 ENG Cut excess corner cover off. 10-2 ENG Slide corner cutting fixture S into place, and clamp onto side of cover being discarded. O (4) I E J ENG Do not clamp fixture on wrong side of cutting line. 20 2020-07-13 #:146-9054-4 (2021-10-27) 10-4 ENG File sharp edges of corner cover. Remove adhesive backing. x4 E 10-5 ENG Clean surfaces before applying VHB. 10-6 ENG Attach (4) corner covers with VHB. E (4) 21 2020-07-13 #:146-9054-4 (2021-10-27) ENG This page intentionally left blank. 22 2020-07-13 #:146-9054-4 (2021-10-27) ENG This page intentionally left blank. 23 2020-07-13 #:146-9054-4 (2021-10-27) ENG Warranty ITL Garanzia ESP Garantía CES Záruka FRN Garantie SLK Záruka DEU Garantie POR Garantia www.peerless-av.com/warranty NEL Garantie TÜR Garanti Peerless-AV 2300 White Oak Circle Aurora, IL 60502 Email: tech@peerlessmounts.com Ph: (800) 865-2112 Fax: (800) 359-6500 www.peerless-av.com © 2021, Peerless Industries, Inc. Peerless-AV Europe Unit 3 Watford Interchange, Colonial Way, Watford, Herts, WD24 4WP, United Kingdom Customer Care 44 (0) 1923 200 100 www.peerless-av.com © 2021, Peerless Industries, Inc. Peerless-AV América Latina Av. de las Industrias 413 Parque Industrial Escobedo General Escobedo N.L., México 66062 Servicio al Cliente 01-800-849-65-77 www.peerless-av.com © 2021, Peerless Industries, Inc.