IKRA PATF 20 Solo Cordless Grass Trimmer with Cart

Introduction

IKRA GmbH presents the PATF 20 Solo, a cordless grass trimmer designed for efficient garden maintenance. This manual details its assembly, operation, safety precautions, technical specifications, and warranty information.

Assembly and Operation

Follow these steps for assembling and operating your grass trimmer:

Assembly Steps

• Step 1: Attach the two wheels to the cart frame using the provided bolts and nuts.
• Step 2: Connect the upper handle tube to the lower handle tube.
• Step 3: Attach the trimmer unit to the assembled handle and cart structure. Ensure it clicks securely into place.
• Step 4: Insert the spool with the cutting line into the trimmer head. Ensure the line is correctly threaded.
• Step 5: Insert the battery into the designated compartment until it clicks.
• Step 6: To start, press the safety lock button and then the ON switch. To stop, release the ON switch.
• Step 7: Adjust the cutting angle by rotating the trimmer head to the desired position (e.g., 180°, 30°).
• Step 8: Mount the grass trimmer onto the cart by aligning the mounting points and securing it.
• Step 9: Adjust the cutting height using the provided mechanism, typically offering settings like 35 mm and 55 mm.
• Step 10: Replace the spool by following the instructions, which usually involves removing the spool cover and inserting a new spool.

Troubleshooting (Fault / Erreur / Difetto)

• Issue 1: Trimmer does not start. Possible Cause: Battery not inserted correctly or discharged. Solution: Ensure battery is fully charged and properly inserted.
• Issue 2: Trimmer stops during operation. Possible Cause: Overload or blockage. Solution: Turn off the unit, remove the battery, clear any obstructions, and allow the motor to cool before restarting.

Storage and Temperature

• Store the appliance in a dry, frost-protected location.
• Recommended battery storage temperature: +5°C to +20°C.
• Avoid exposing the battery to extreme heat or direct sunlight.

Technical Data

Technical changes reserved.

Safety Instructions

General Warnings:

• Read and understand the operating instructions before use.
• Keep children, other persons, and animals at a safe distance (minimum 15 m / 49 ft).
• Do not use the appliance if you are tired, ill, or under the influence of drugs, alcohol, or medication.
• Ensure adequate lighting and good footing at all times.
• Do not use in bad weather, especially with lightning risk.
• Do not overreach; maintain balance. Walk, do not run. Be careful when moving backward.

Personal Protective Equipment (PPE):

• Wear safety goggles. ?
• Wear ear protection. ?
• Wear sturdy shoes and long trousers.
• Do not wear loose clothing or jewelry. Keep hair, clothing, and gloves away from moving parts.

Vibration and Health:

• Prolonged exposure to vibration can cause hand-arm vibration syndrome.
• Use vibration damping systems and take regular breaks. Keep hands warm.
• Monitor hand and wrist condition; seek medical advice if symptoms appear.

Noise:

• Noise levels can cause hearing damage. Always wear ear protection.
• Schedule noisy work during permitted hours and limit usage duration.
• Observe local noise protection regulations.

Electromagnetic Field:

• This tool generates an electromagnetic field. Consult a physician and implant manufacturer if you have active or passive medical implants.

Risk of Injury from Cutting Elements:

• Be cautious of rotating cutting elements. Keep hands and feet away from the cutting mechanism.
• Never reach under the housing while the motor is running.
• Ensure protective covers are in place and undamaged.
• Inspect the work area for stones, branches, wires, or living creatures that could be thrown.

Appliance Condition:

• Do not use a damaged appliance or one with defective safety equipment.
• Replace worn or damaged parts.
• Check all connections and ensure moving parts are free.
• Never modify or remove safety devices.
• Do not use metal cutting elements.
• Keep cables away from the cutting device.
• Do not lock the ON/OFF or safety switches.
• Disconnect power (remove battery) before leaving the appliance, removing blockages, cleaning, or performing maintenance.
• If the appliance vibrates abnormally, stop immediately and find the cause.
• Carry the trimmer by the handle with the motor off. Remove the battery for transport or storage.
• Store in a dry, frost-protected place, out of reach of children.

Symbols:

• ⚠️ WARNING! Please read the operating instructions carefully before use.
• ? 20 V DC Battery Voltage
• ↔️ Cutting Diameter: 300 mm
• ? Sound Power Level: 96 dB(A)
• ? Wear eye protection!
• ? Wear ear protection!
• ? Wear safety shoes with cut protection, non-slip sole, and steel toe cap!
• ❗ Warning against thrown-off items: Keep others at a minimum distance of 15 m (49 ft).
• Do not expose to rain or use in wet conditions.
• Remove the battery before any adjustment, cleaning, or maintenance.

Intended Use:

• The grass trimmer is designed for cutting grass and weeds in gardens, along flower beds, and borders.
• It is intended for cutting small lawns in private domestic and hobby gardens.
• Do not use for cutting hedges, hard branches, wood, or compost material.
• Do not cut grass not on the ground (e.g., on walls, rocks).
• Do not use metal wire or plastic-sheathed metal wire in the cutting head.
• Do not use near flammable liquids or gases.

Battery and Maintenance

Battery Handling:

• Recharge batteries only with manufacturer-recommended chargers.
• Use only designated battery packs for this tool.
• Keep unused batteries away from small metal objects (paper clips, coins, keys) to prevent short circuits.
• Avoid contact with ejected battery liquid; flush with water if contact occurs. Seek medical help if liquid gets into eyes.
• Do not use damaged, defective, or deformed batteries.
• Never open, damage, or drop batteries.
• Charge batteries between 10°C and +40°C, away from heat and flammable materials.
• Allow batteries to cool down after heavy use.
• Seal battery contacts for disposal, transport, or storage.

Maintenance:

• DANGER: Remove the battery before any adjustment, cleaning, or servicing. Wait for all moving parts to stop and the appliance to cool down.
• Keep the device, especially ventilation slots, clean. Never spray water on the device body.
• Clean with a damp cloth only; do not use solvents or flammable liquids.
• Use only original accessories and spare parts.
• Regular maintenance ensures satisfactory performance and prevents accidents.
• Repairs not described in this manual should only be performed by qualified personnel.
• Store the device in a dry, frost-protected, and locked location.

Disposal

• Do not dispose of electrical appliances, batteries, or rechargeable batteries with household waste.
• Collect them separately and return them to an environmentally compatible recycling facility.
• Contact local authorities or retailers for recycling information and collection points.
• Batteries may contain substances harmful to the environment and human health.
• Dispose of batteries separately from the appliance.
• For models in Germany: You are obligated to return the device to a recycling center.
• For batteries containing mercury (Hg), cadmium (Cd), or lead (Pb), specific disposal instructions apply.
• Transport packaging should also be recycled. Keep packaging parts away from children.

Warranty Conditions

Warranty Provider: IKRA GmbH, Schlesier Straße 36, D-64839 Münster-Altheim, Germany.

Standard Warranty: 24 months from handover. Proof of purchase (original invoice or copy) is required.

Applicability: For consumers only, for new goods purchased within the EU, UK, and Switzerland.

Exclusions: Wearing parts, batteries, damage from incorrect accessories, non-original parts, force, impact, breakage, motor overload.

Limitations: Warranty covers defective parts, not complete devices. Repairs must be done by authorized service partners. Unauthorized intervention voids the warranty.

Shipping Costs (Germany): Borne by IKRA GmbH for warranty cases.

Additional Warranty (Primaster): 60 months provided by Globus Fachmärkte GmbH. Similar exclusions apply. Not valid for commercial use. Shipping costs are borne by the buyer.

Governing Law: German law applies, excluding the UN Convention on Contracts for the International Sale of Goods (CISG).

EC Declaration of Conformity

IKRA GmbH declares that the Cordless Grass Trimmer PATF 20 Solo complies with the relevant safety and health requirements of EU Directives (2006/42/EC, 2014/30/EU, 2000/14/EC, 2011/65/EU).

Harmonized Standards Used: EN 60335-1, EN 50636-2-91, EN IEC 55014-1, EN IEC 55014-2, EN IEC 63000.

Serial Number Range: 3495140000001 - 3495149999999.

Conformity Assessment: Notified Body: TÜV SÜD Industrie Service GmbH. Measured Sound Power Level: 93.53 dB(A). Guaranteed Sound Power Level: 96 dB(A).

Date: Münster, 2024-07-11

Contact for Technical Documentation: Yi Zhou, IKRA GmbH.

Service Information

For current service addresses, please visit: www.ikra.de