Ice Shaver Operation Manual
Model No.: BY-168
IV. Notes
- Please use ~110V/220V voltage.
- The machine lid has a safe protective device; if the top head is not covered, the machine won't start even if the starting switch is pressed.
- Please place the machine on a smooth surface. The ice pieces invested must be even; otherwise, it can cause fuselage vibration.
- The height of the ice quantity in the trough should be 1cm below the red line.
- Please clean the trough after working.
- Please do not touch the blade to prevent injury.
- Do not dismantle the machine when cleaning.
Operation Overview
Notice: If the machine is jammed by ice, press the switch to Reverse.
Controls: Reverse, OFF, Rough, Fine
- Open the top cap and put the ice cube inside, then close the cap.
- Plug into the power supply and switch "ON" for crushing.
- Turn the granule size adjuster to crush the ice cube as required.
Matters needing attention: Please break heavy ice lumps into pieces before starting, otherwise, the motor may be damaged.
Technical Parameters
| Overall Size | 290mm x 390mm x 430mm |
| Power Supply | 110V~120V, 220V~240V / 50~60Hz |
| Specified Current | 3.5A |
| Speed Range | 320R/M |
| Specified Power | 250W |
| Productivity | 120Kg/H |
| N.W. | 12Kg |
Parts Identification
A textual description of the ice shaver: A white and blue electric ice shaver machine with a clear ice exit chute at the bottom and controls on the front. It has branding stickers on the front and sides.
Diagram labels:
- 1. The entrance for adding ice
- 2. Power switch
- 3. Exit for ice
- 4. Blade adjuster
- 5. Base
Operation Instructions
Please read this manual carefully before use. Technology is subject to change without notice.
- Open the lid, clean the ice trough with a dry towel, and check whether the blade is installed firmly.
- Please check the power line and the plug for any damages. Ensure leakage phenomena are absent and contacts are good. Close the switch and insert the power source.
- Open the machine lid, invest the right amount of ice pieces, then cover the top head.
- Press down the starting switch on the front of the machine.
- According to your needs, adjust the blade adjuster to process ice with different thickness.
- The use of ice pieces with a diameter of 3-5cm is best; you may also pound large ice into smaller ones.
