DF5200 8 Pair Vertical Dumbbell Rack Assembly Manual

Box Contents

The following components are included in the DF5200 8 Pair Vertical Dumbbell Rack package:

• A: BODY ASSEMBLY - QTY 1
• B: BASE - QTY 1

Hardware

The necessary hardware for assembly includes:

• C: 10MM BOLT - QTY 6
• D: 10MM LOCKNUT - QTY 6
• E: PLASTIC PROTECTOR - QTY 32
• F: LOCKING PIN - QTY 32

Note: If you are missing hardware or have any fit-up problems, please contact Deltech Fitness toll-free at (888) 258-0533.

Tools Required

• Metric Wrenches or Socket Set
• 4MM Hex Wrench

Assembly Instructions

Step 1: Attach Body Assembly to Base

Assemble one side of the Body Assembly (A) to the Base (B) using three 10MM Bolts (C) and three 10MM Locknuts (D). The diagram shows the Body Assembly (A) being attached to the Base (B) with bolts and nuts passing through pre-drilled holes.

Step 2: Align and Secure Second Side

The Body Assembly is designed to be flexible, allowing it to easily move to align the remaining three holes if necessary. Once the alignment is correct, attach the second side of the Body Assembly to the Base using the remaining three 10MM Bolts (C) and three 10MM Locknuts (D).

Step 3: Install Plastic Protectors

To install the Plastic Protectors (E), slide them down onto the edge of the rack. Once in place, rotate each protector clockwise and slide it backward until the hole in the protector aligns with the corresponding hole in the dumbbell rack.

Step 4: Insert Locking Pins

Insert a Locking Pin (F) into the hole of each installed Plastic Protector (E). Ensure the pin passes through the aligned hole in the dumbbell rack and push until it locks securely into place. This secures the plastic protectors.

Safety Notice

WARNING: The user of this weight equipment assumes the possibility of injury by exercising on this equipment. The possibility of risk can be reduced by always following these simple rules:

1. Before beginning any exercise program, consult your doctor for a complete physical examination and suggested exercise program specific for you.
2. Stretch before and after the exercise program. Proper stretching will prepare your joints and muscles for exercise and help avoid injuries.
3. If at any time you should feel faint or dizzy, nauseous, or experience any other abnormal symptoms or discomfort, discontinue use and consult your doctor.
4. Do not use this equipment without qualified supervision and proper training. Never work out alone; always have a partner.
5. Securely tighten all bolts and regularly check to ensure all bolts have not loosened.
6. Wear good rubber sole shoes only. Do not use bare footed or with socks only.
7. Do not wear loose clothing such as robes, gowns, pants, long shirts, or jewelry which could become entangled in moving parts.
8. Do not stand or kneel on the seat; always sit or lay squarely centered.
9. Keep head, limbs, and body parts clear of moving parts and weight plates.
10. Children should not use exercise equipment without supervision because of the possibility of injury from improper usage. This equipment is intended for home use only.
11. Replacement of worn or defective parts must be done with factory-authorized parts. If other than factory-authorized parts or assessors are used, all warranties and liabilities become void.