Installation Guide for AViANCE models including: HD77775, 44956a91-56e5-48eb-801d-c1a171f0d5d6, HD77614, HD77775 Belhaven 1 Light Brushed Nickel Pendant, HD77775, Belhaven 1 Light Brushed Nickel Pendant, Brushed Nickel Pendant, Nickel Pendant
3 days ago — ASSEMBLING THE FIXTURE (Fig.1). 1. Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box.
ASSEMBLING & INSTALLATION INSTRUCTIONS The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product. HD77775 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER. ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR. ASSEMBLING THE FIXTURE (Fig.1) 1. Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box. 2. Carefully unpack your new fixture and lay out all the parts on a clear area. Be care not to lose any small parts necessary for installation. 3. While holding the lamp body(C) towards the ceiling, attach the single bar to the Junction Box with the two junction box screws as shown. The side of the single bar marked "GND" must face out. The junction box is not included. 4. By measuring, determine correct cord length needed for proper hanging height. NOTE: slide wire clip to the proper position, then you may properly cut the cord to desired length. 5. Connect the electrical wires as Shown in Fig.2, making sure that all wire nuts are secured. You may have to wrap the connections with electrical tape. If your outlet has a ground wire (green or bare copper), connect the fixture ground wire to it. Otherwise connect fixture's ground wire directly to the Mounting plate with the green screw provided. After wires are connected, tuck them carefully inside the Junction Box. 6. Install the canopy(A) onto the junction box, the pipe thread protrude from the hole in the canopy and rotation the coupling(B) until tighten it, then lock it securely with the plastic screw. 7. Install the light bulb(Not included) in accordance with the fixture's specifications. NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE! FIG.1 Cord clip FIG.2 FIXTURE WIRES BLACK FIXTURE WIRES WHITE HOUSE WIRES Black (Hot) HOUSE WIRES White (Neutral) FIXTURE WIRES GREEN Thread (Ground) HOUSE WIRES Green or Bare Copper(Ground) Your installation is now complete. Return power to the junction box and test the fixture. Thank you for purchasing an AVIANCE product. Need assistance with parts or assembly? Please email customer service at:info@aviancelighting.net ©COPYRIGHT ALL RIGHTS RESERVED. AVIANCE LIGHTING,INC. DOC202503HD77614Acrobat Distiller 9.3.2 (Windows)