User Manual for Anko models including: Camp Caravan Thermometer, 42965824

1. Introduction 2. Getting Started

User Manual CAMP CARAVAN THERMOMETER Keycode: 42965824 1. Introduction The following user guide provides step by step instructions for installation and operation. 2. Getting Started 2.1 Parts List ... 1/12/2021 12:03:56 PM ...

User Manual CAMP CARAVAN THERMOMETER Keycode: 42965824 1. Introduction The following user guide provides step by step instructions for installation and operation. 2. Getting Started 2.1 Parts List QTY Item 1 Display Console Frame Dimensions (LxWxH): 7.5 x5.8 x 1.9cm LCD Dimensions (LxW): 4.1 x5.2cm 1 Manual 2.2 Display Console Set Up

1. Introduction 2. Getting Started - Kmart

User Manual. CAMP CARAVAN THERMOMETER. Keycode: 42965824. 1. Introduction. The following user guide provides step by step instructions for ...

• Google Docs
• Google Drive
• Download [pdf]
• Download Optimized
• Document:
  • Text

File Info : application/pdf, 4 Pages, 171.74KB

User Manual
CAMP CARAVAN THERMOMETER Keycode: 42965824

1. Introduction
The following user guide provides step by step instructions for installation and operation.

2. Getting Started

2.1 Parts List

QTY 1

Item Display Console Frame Dimensions (LxWxH): 7.5 x5.8 x 1.9cm LCD Dimensions (LxW): 4.1 x5.2cm

1

Manual

2.2 Display Console Set Up
Note: To avoid permanent damage, please take note of the battery polarity before inserting the batteries.
BEFORE inserting the batteries, change Celsius/Fahrenheit Switch FIRST (the default is Celsius) Figure 1- if necessary. If you want to change the temperature unit when the unit is working you need to take out the batteries first. Then switch C/F as Figure 1 and re-insert batteries. Important: You need to change temperature unit (C/F) before the item is powered on.

Figure 1 Remove the battery door on the back of the display. Insert two AAA (alkaline or lithium)
batteries in the back of the display console, as shown in
Figure 2.
Figure 2 All of the LCD segments will light up for a few seconds to verify all segments are operating

properly.
Verify the correct temperature unit of measure (°F vs. °C) are on the display as shown in Figure 3

1.Out temperature unit (°F or °C) 2.Outdoor lowest temperature 3.Indoor temperature unit (°F or °C) 4.Indoor lowest temperature 5.Indoor highest temperature

Figure 3
6. 24hours automatically cleared 7.Indoor temperature 8.Outdoor highest temperature 9.Outdoor temperature

Replace the battery door, then fold out the desk stand and place the console in the upright position, as shown in

Figure 4.

Figure 4

2.3 Sensor Operation Verification
Verify the indoor and outdoor (probe) temperature match closely. The sensors should be within 2°C (the accuracy is ± 1°C). Allow a few minutes to stabilize.

3. Specifications

3.1 Measurement Specifications
The following table provides specifications for the measured parameters.

Measurement

Range

Indoor Temperature 0~60ºC

Outdoor Temperature -40 to 60 °C

Accuracy ± 1 °C
± 1 °C

Resolution 0.1 °C
0.1 °C

3.2 Power Consumption
· 2 x AAA 1.5V Alkaline batteries · Battery life: Minimum 24 months for base station

Made in china