Assembly Instructions
Step 1: Prepare the Base
Attach bracket D to the main base component. Use the provided screws.
[Diagram: Shows bracket D being attached to a base piece with screws.]
Step 2: Insert Rods
Insert rods G and H into the designated slots on bracket D. Ensure they are securely fitted.
[Diagram: Close-up view showing rods G and H being inserted into bracket D.]
Step 3: Generic Rod Illustration
This step illustrates a generic rod (marked 'X') for reference, possibly indicating alignment or measurement points.
[Diagram: A rod labeled 'X' is shown with dashed lines indicating measurement or alignment.]
Step 4: Wall Preparation
Mark the wall for mounting. Drill a hole into the wall, ensuring a depth of 1/4 inch (6mm) and an angle of approximately 15 degrees for secure mounting.
[Diagram: Shows a drill bit entering a wall at an angle, with measurements 1/4" (6mm) and 15° indicated.]
Step 5: Mount to Wall
Attach the assembled unit to the wall using screws A and B, secured by bracket C. Ensure the bracket is firmly attached to the wall.
[Diagram: The main assembly is shown being attached to the wall with screws A and B, using bracket C.]
Step 6: Attach Frames
To attach the photo frames (I and J) to the rods (E and F):
- EN: Pull out two clips, insert frame, slide clips back.
- FR: Retirer deux clips, insérer le cadre, remettre les clips.
- ES: Saque dos clips, inserte el marco, vuelva a colocar los clips.
- IT: Estrarre due clip, inserire la cornice, reinserire le clip.
[Diagram: Close-up showing how to manipulate clips to attach a frame to a rod.]
Step 7: Final Hanging
Hang the assembled display unit from the wall mount. The frames will hang from the rods.
[Diagram: Shows the completed display unit hanging from the wall, with multiple frames suspended below.]
