Jewenwils Outdoor Digital Timer

Please pay attention to the warning signs. Read the instructions with caution before operating and keep them properly.

WARNING

• TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK OR PERSONAL INJURY, PLEASE STRICTLY FOLLOW THE INSTRUCTIONS.
• SUITABLE FOR USE WITH OUTDOOR APPLIANCES RAINTIGHT WHEN MOUNTED VERTICALLY WITH THE RECEPTACLE FACING DOWNWARD. NOT FOR WATER IMMERSION. STORE INDOOR WHEN NOT IN USE.
• INSTALL THE CORD AND UNIT ABOVE GROUND LEVEL AT LEAST 1.4 M WITH THE RECEPTACLE FACING DOWNWARD.
• DO NOT CONNECT ANY DEVICES WHICH EXCEED THE MAXIMUM RATINGS OF THE TIMER.
• DO NOT IMMERSE IN WATER.
• CHILDREN ARE NOT ALLOWED TO USE THE TIMER WITHOUT SUPERVISION.
• DO NOT DISASSEMBLE OR REPAIR THE PRODUCT, BUT ONLY BY AUTHORIZED SERVICE PERSONNEL.
• ALWAYS UNPLUG AND STORE INDOORS WHEN NOT IN USE.

Product Layout

The Jewenwils Outdoor Digital Timer features a compact design with an integrated cord and plug. Key components include:

• Light Sensor: This sensor activates the timer at dusk and deactivates it at dawn.
• Display: Shows the current operating mode.
• Select Button: Used to choose and switch between operating modes.

Operation Instructions

To operate the timer, plug it into a standard outlet. Press the select button to cycle through the following settings:

• * Cycle repeats every 24 hours.
• * Once activated at dusk in a specific mode, the program cycle will complete. External light sources will not interfere with the program cycle.

HELPFUL TIPS

• When set to "ON", the timer provides continual power to attached devices until switched to "OFF" or another operating mode.
• In sensor mode, temporary light sources (e.g., headlights, porch lights) will not interfere with the photocell function unless the external light source is on for more than 15 minutes. In such cases, the timer will shut off until darkness is restored, preventing flickering.
• Once programming activates at dusk in the 1-9 hour mode, the program cycle will complete before the timer resets. External light sources will not interfere with the active timer program.

Electrical Ratings

• Input Voltage: 125V, 60Hz.
• Max Power Rating:
  • 125V, 60Hz, 1625W
  • 13A Resistance
  • 13A General Use
  • 1000W Tungsten
  • 500VA Electronic Ballast
  • 120Vac, 60Hz, 8.3A Ballast
  • 1/2HP
• Cord: SJTW 16/3 AWG.

Safety Information

Federal Communications Commission Interference Statement

This equipment has been tested and complies with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy. If not installed and used according to instructions, it may cause harmful interference to radio communications.

There is no guarantee that interference will not occur in a particular installation. If this equipment causes harmful interference to radio or television reception (determinable by turning the equipment off and on), the user is encouraged to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for assistance.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.

One Year Limited Warranty

Supported by a professional R&D and QC team, a One Year Warranty is provided for materials and workmanship from the purchase date. The warranty does not cover damage caused by personal misuse or improper installation.

Customers should attach their Order ID and Name for assistance from the dedicated customer service team.

Product is CULUS LISTED and Made in China. The product packaging indicates it is recyclable (♻).