User Manual for WINNERCOM models including: CE, 2AU37CE, CE NFC, Touch Door Handle, CE NFC Touch Door Handle, NFC Touch Door Handle, Touch Door Handle, Door Handle, Handle
WINNERCOM CO,. LTD CE 2AU37CE 2AU37CE ce
File Info : application/pdf, 7 Pages, 826.02KB
DocumentDocumentWINNERCOM Com pa ny na m e WINNERCOM WINNERCOM CE NFC Touch Door Handle User Manual V 1.0 Winnercom Co., Ltd. W I N N ERCOM Contents 1. Introduction 2. NFC Door Handle Design(BOM) & Application 3. Attentions 4. Specifications 5. User Information and Instructions W I N N ERCOM 1. Introduction Door handle Module (DHS) NFC & Capacitive Touch Pocket Light LED Hi-Speed CAN The door handle module for Automotive has a NFC Reader and lock/Unlock 2Channel Capacitive touch Sensor function. This module is installed inside of the door handle covers and will be attached to the outside door panel. This module is communicated with CAN network which enables to connect to the car network to send the signal of lock and unlock of door and Pocket light LED On/Off control. It receives DC power from car battery at all time. [ Door Handle Out-Side ] [ Door Handle In-Side ] [ Assembled cover and DHS] 2. NFC DHS Design(BOM) & Application W I N N ERCOM CE - NFC Touch Door Handle ITEMS Size Color Weight Waterproof Material SPECIFICATION 125 x 18 x 20 mm (Length x Width x Height) Black 53g +/- 2.2% Polyurethane full potting inside of module. Protective of humidity ,vibration, waterproof. Case : PA6+GF15% , ABS / PRESS : SPTE(Tin-Plating) / PCB : FR-4, 4Layer / Foam Tape : EPDM/ FPCB : Polyimide film 3. Attentions W I N N ERCOM Please always mount the Door handle Module before power on the device to avoid circuit damage Before power on the Module, check the power supply(Fig. 1) Module Input Power connect to the connector(Fig. 1) Fig. 1 Connector 4. Specifications W I N N ERCOM NFC Touch Data Frequency Range Operating Voltage Current Operating Temp. Storage Temp. Symbol 13.56MHz for NFC 9.0 ~ 16.0 [Vdc], Typical 12.0 [Vdc] Max 400mA @ Operation Mode -30 ~ 75 -40 ~ 85 DC, IEC 60417-5031 (2002-10) [ System Block Diagram ] 5. User Information and Instructions W I N N ERCOM FCC Part 15 Compliance information. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions : (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Caution Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage ; (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. - This product is compliant with the essential requirements and other relevant provisions of the Directive 2014/53/EU. - This product can be used in which EU members, in accordance with ArticleS10(10). Manufacturer information Manufacturer name WINNERCOM Co., Ltd. Address, City: HUMAX Village, 216, Hwangsaeul-ro, Bundang-Gu, Seongnam-si, Gyeonggi-do, South KOREA 13595 Product name (type) : Vehicle active antenna & Touch doorAdobe PDF Library 15.0