Installation Guide for Wiser models including: CLP501902 Hub Zigbee to IP Network, CLP501902, Hub Zigbee to IP Network, to IP Network, IP Network, Network
Clipsal | CLP501902 | WISER HUB | John R Turk Electrical Supplies
File Info : application/pdf, 1 Pages, 1.10MB
DocumentDocumentR R R CLP501902 PDL501902 ! A ,, J B C D KLM I § a. R b. R R $ au GND E F G To access the Wiser devices in your home, please scan the QR code below and follow the instructions provided. Invitation Code: Installer Company: Telephone: H N O P R nz Wiser Hub Prerequisites Download the Wiser by SE app to your smartphone. About this product The Wiser Hub (hereinafter known as Hub) is a communication interface that can be connected to all your Wiser Zigbee devices, enabling you to easily manage your home environment. Functions · Monitors and controls Wiser Zigbee devices through the mobile app, Ethernet or Wi-Fi®. · Create Moments or Automations to operate Wiser Zigbee devices through the mobile app. 1 Package contents A Wiser Hub B Screws: 2 × ST4.2 × 25 mm with wall plug C AC adaptor D AC adaptor USB cable E Ethernet cable F Reset pin G Installation instructions H Hand over card 2 Operating elements I Reset button J Power button K Ethernet LED L Wi-Fi® LED M Zigbee LED N Ethernet port O Terminals for power supply (12 VDC) P Micro USB port for the AC adaptor 3 Installing the Hub DANGER HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH · It is illegal for persons other than an appropriately licensed electrical contractors or other persons authorised by legislation to work on the fixed wiring of any electrical installation. · To comply with all safety standards, the product must be used only for the purpose described in this instruction and must be installed in accordance with the wiring rules and regulation in the location where it is installed. · Lock out and tag the input circuit before accessing the wiring connections. · There are no user serviceable parts inside the product. Failure to follow these instructions will result in death or serious injury. NOTICE EQUIPMENT DAMAGE · If the Hub is powered through the micro USB port, use the provided AC adaptor only. · If the Hub is powered on through the terminals, use a suitable 12 VDC power supply only. Failure to follow these instructions can result in equipment damage. DANGER HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH Make sure that the 12 VDC power supply is turned off before making connections to the Hub. Failure to follow these instructions will result in death or serious injury. a. Wall It is recommended to use the supplied AC adaptor to power the Hub. b. Table · Use the tablestand for Wiser Hub CLP501902_0001 or PDL501902_0001 when placing the Hub on a table. · It is recommended to use the supplied AC adaptor to power the Hub. 4 Read full system user guide online Scan the QR code to access the Wiser - System User Guide for complete information about the device, including operation, configuration and using the system. Technical data AC power adaptor Power supply Connector type Model number: KA0601A-0501000AUU Input: 100-240 VAC, 50/60 Hz Output: 5.0 VDC, 1.0 A, 5.0 W Average active efficiency: 73.7% @115 VAC, 230 VAC No-load power consumption: 0.1 W @115 VAC, 230 VAC 5 VDC/1.0 A AC power adaptor through micro USB port 12 VDC/0.5 A power supply through 2-pin terminal block (not included in the package) Micro USB port for the AC adaptor 2-pin terminal block cable type: 0.25 mm2 to 1.50 mm2 Communication interface Operating frequency Max. radio frequency power transmitted System clock IP rating Operating temperature Relative humidity Dimensions (H × W × D) Communication protocol Compliance Ethernet: IEEE802.3, 10/100 base-T (LAN) Wi-Fi®: 2.4 GHz, IEEE802.11 b/g/n Zigbee: 2.4 GHz, IEEE802.15.4 2405 - 2480 MHz (Zigbee) 2412 - 2472 MHz (Wi-Fi®) <10 mW (Zigbee) <67 mW (Wi-Fi®) RTC function with coin battery (CR1220) IP20 0 °C to 40 °C, indoor use only 10 % to 90 %, non-condensing 86 × 86 × 34 mm Zigbee 3.0 certified Trademarks · WiserTM is a trademark and the property of Schneider Electric SE, its subsidiaries and affiliated companies. · Zigbee® is a registered trademark of the Connectivity Standards Alliance. · Apple® and App Store® are brand names or registered trademarks of Apple Inc. · Google PlayTM Store and AndroidTM are brand names or registered trademarks of Google Inc. · Wi-Fi® is registered trademark of Wi-Fi Alliance®. Other brands and registered trademarks are properties of their relevant owners. Schneider Electric (Australia) Pty Ltd 33-37 Port Wakefield Road, Gepps Cross SA 5094 Customer Care: 13 73 28 Email: customercare.au@se.com Warranty: https://www.se.com/au/en/about-us/legal/ terms-and-conditions.jsp www.se.com Schneider Electric (NZ) Ltd Building 6, 60 Highbrook Drive, East Tamaka, Auckland 2013 Customer Care: 0800 652 999 Email: sales@nz.schneider-electric.com Warranty: https://www.se.com/nz/en/about-us/legal/ terms-and-conditions.jsp www.se.com NNZ5867307-02 01/2022